3-7/16" x 3-1/2" Square. LED utility light produces a bright light. Flood beam illuminates a wide area. Great White series features custom-cut lens optics and ultra-bright white diodes. Durable aluminum housing. Pedestal mount.
Features:
Specs:
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Today we're going to take a quick look at the Peterson Great White LED Work Light. This is going to be a flood beam design and the nice thing about this light is that it's going to be a very durable, rugged housing.It's going to be made of a nice, die-cast aluminum with a matte black, powder coat finish and our polycarbonate lens is going to be impact resistant. Overall, the whole this is IP-68 rated, which pretty much means that it's impervious to dust and water so very durable, long-lasting light.Also, since our light is going to be an LED, we don't have to worry about changing out any bulbs, no filaments that can break with this so there's pretty much no maintenance required with this light.As far as our light output, it's going to give us 1,350 lumens, so, very bright. Flip on our switch here, and you can see it's going to be pretty blinding. Turn out the lights in the studio to give you a better idea of what that's going to be like in low-light situations. Flip this over and bring that light out, about as far as my hand, or, as far as my arm span and still very bright light.
Gives you a nice white light, either as a work light, utility light, you can have it on your off-road vehicle, maybe you've got a work shed, something like that.That flood beam is going to illuminate a wide area and again, nice, durable housing means that this is going to be a very long-lasting light.The fins on the back are going to channel out any heat that might build up so it's going to have a greater surface area to disburse heat and it does come with an adjustable bracket at the bottom. It's going to be just that little steel arm with our hardware to get that attached to any surface we want to mount it up to and then you can adjust the angle from there.Overall, this is going to measure about four inches across by about five inches going from the top of the light to the bottom of the bracket and then about an inch and a half in depth.We'll have 12 diodes in all, or, excuse me, one, two, three, four, five, six, seven, eight, nine diodes in all so this is going to be a very bright light for us. The power draw at 12-volts is going to be 1.29 amps and at 24-volts, it's going to be 0.64 amps. The operating voltage is 9, between 9-volts and 32-volts and the LED's do have a limited lifetime warranty from Peterson.We'll just have two wires to connect to get our light to function. Black wire will be for ground, red wire's for power.
The length on our wiring is going to be about 15-inches long.And that's going to do it for our look at the Peterson Great White LED Work Light.
Average Customer Rating: 4.9 out of 5 stars (66 Customer Reviews)
3-7/16" x 3-1/2" Square. LED utility light produces a bright light. Flood beam illuminates a wide area. Great White series features custom-cut lens optics and ultra-bright white diodes. Durable aluminum housing. Pedestal mount.
Ordered these to add as lights inside my Decked truck bed cargo system. Work great. Note: To wire this up for a Decked cargo box inside light, you can either do a waterproof toggle switch, or go with a magnetic switch like you would use for an alarm system. I did the latter. You can tap into your bed lighting or to a constant 12vdc at the trailer harness. The magnet switches are set so that the lights turn on when I pull a drawer open, and off when I shut it. Attached some photos to show what they look like
The light itself is great! It would work better if there was a deeper recess on the bottom where it mounts to the trailer. This would help conceal the wiring and extend the light toward the rear of the trailer to better illuminate the license plate.
Very Nice Item
Well built, easy installation. Great people to do biz with
Have actually used used these in different setups. 2 enclosed trailers, a 10' long and 22 ' long. Also used 2 for pickup truck bed lighting mounted under the rails of a tonneau cover.
they have worked very well
This was a great replacement for the original lic plate light. I did have to drill one new hole because the new light base was a tad wider than the original base. The wiring was very simple: hot and ground and it worked like a champ.
Reordered after breaking on install. It wasn’t the products fault. Someone shut the trailer door on it just prior to final install and broke the lens. Light still works! Quality product!
Used to replace corroded incandescent back-up lights on trailer, these work great, easy to wire in, great illumination.
Getting ready to put this 2nd set into my trailer. Tied them right into the cheap ceiling lights and really brightened it up inside.
Very good bright light. Running for a year now and no issues.
This light was easy to mount and connect. Add a great amount of light
LEDs nice and bright easy to view way better than the traditional incandescent bulbs that were replaced
Excellent product, much better than the plastic one I replaced. Looks good on my trailer.
Worked great as a replacement light for my ARE commercial truck topper!
Excellent product and I will buy it again for my next trailer.
Working great, 1 year later. Perfect fit on my motorhome.
These lights are so nice I just ordered two more to complement the inside of my trailer
Just received my order in timely manner, can wait to get them installed! Thank you etrailer
Nice light. Easy website to navigate. Quick and easy to track shipping.
Good product, looks good and works well ..
Worked as expected-though could be brighter - no issues as of now.
Fit and finish were good and light is working as it should.
Installed easily and works well
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.