Yakima 54" Tracks for Roof Racks

See what our Experts say about this Yakima Roof Rack

• Best Roof Rack System for 2001 Ford E350 Van
  The gutter mounts we have are actually really sturdy if you get the right ones and install them right. Technically, you should have more weight capacity off the gutter mounts since the weight is distributed vertically through the gutters vs racks bolted onto your fiberglass roof. A good system for your 2001 Ford E350 Van is the Rhino Rack system with Square Crossbars # RB1800B-2 and Gutter Feet # RL150S10. You can switch the square crossbars for aero ones with 71" Vortex Aero Crossbars...
  view full answer...
• Recommended Roof Rack For Nucamp Camper
  You could use Yakima 54" Tracks for Roof Racks # Y01127 along with Yakima Control Tower (QTY 1) # Y8890027. You could then add any Yakima round bar such as Round 66" CrossBar (QTY 1) # Y8810025 or Round 78" CrossBar (QTY 1) # Y8810027. This is a common setup used on camper shells and campers; it is mounted on a flat roof. I attached a demonstration video for you.
  view full answer...
• How To Use Yakima Round Crossbars With Tracks On Bed Rails
  In order to use round crossbars on top of the bed rails you'll have to start with the tracks; then you can add the feet, landing pads, and crossbars. The feet are only offered in one height unfortunately but nonetheless I will attach a list of all the parts you'll need below. There isn't an all inclusive kit. Yakima Roof Track part # Y01127 Landing Pads part # Y00221 (2) Mounting Foot part # Y8890027 (4) Round Crossbars part # Y00411 (Cut To Fit)
  view full answer...
• Can Yakima Tracks Work on Truck Cap and Roof
  You can add the Yakima Tracks for Roof Racks, which come in 60" # Y01135, 54" # Y01127 or 42" # Y01126 to your 2015 Ford F-150 although I could not tell from the photo if there was a space between the truck cap and the roof of your truck. If there is a space between them you wouldn't want to install just the two tracks per side as that wouldn't be fully secure. As for the rivets showing, they won't specifically, but the CapNuts in the hardware would show because you need to drill through...
  view full answer...
  
• What Crossbar System Accommodates a Rooftop Tent on My 2017 Honda Accord?
  For your 2017 Honda Accord with a bare roof without fixed mounting points, the best option is a system that involves drilling. This is because all of the non-drilling options for your vehicle include door jamb clamps that are not recommended for supporting the extra weight associated with a roof top tent setup. Manufacturers strongly discourage this because door jamb clamps setups can buckle and become detached with the weight. With that being said, I recommend the following track system:...
  view full answer...
• What Landing Pads do I Need to Use the 54 Yakima Tracks # Y01127?
  For the Yakima Tracks - 54" # Y01127, you need a set of the Landing Pad 1 for Yakima SkyLine and Control Towers - Qty 2 # Y00221 for each crossbar. In addition to that, to have a complete setup, I recommend using the SkyLine Towers for Yakima Crossbars - Track Systems - Qty 4 # Y53TR and the Yakima JetStream Crossbars - Aluminum - Black # Y00425 (50 inches) or the # Y00426 (60 inches).
  view full answer...
• Yakima Round Bar Complete Roof Rack System With Tracks
  You can piece together a round bar system that is going to be similar to a Yakima roof rack with round bars and a track system. What you will need are the following parts: - Yakima 54" Tracks for Roof Racks # Y01127 - Yakima Control Tower # Y8890027 (Quantity of 4) - Landing Pad 1 for Yakima Control Towers # Y00221 (Quantity of 2) - Round 58" CrossBars for Yakima Roof Rack System # Y00409 OR Round 66" CrossBars for Yakima Roof Rack System # Y00410 This will give you a track-based roof...
  view full answer...
• Roof Tracks for a 2016 Toyota Tacoma
  The Yakima Track, part # Y01127 is not a direct fit for the 2016 Toyota Tacoma, but provided you have the required 54 inches on the roof of the vehicle, you could install it, however you'd need to drill new holes for this installation, as it's unlikely that the Yakima Track's holes will line up. There isn't another product that is designed to specifically fit the 2016 Toyota Tacoma. Generally, our pictures are from customers who have asked us to do the install for them, and on this product,...
  view full answer...
• Roof Rack Option For 2016 Toyota 4Runner With Factory Rails
  The standard roof rack fits for your 2016 Toyota 4Runner are all designed for the factory raised rails, but since you said you were okay with drilling holes you could add a track system to your roof. You would use whichever length is right for your 4Runner, the Yakima 42" Tracks for Roof Racks # Y01126 or 54" Tracks # Y01127. Then you'd just need the following: - Yakima JetStream Crossbars # Y00425 - SkyLine Towers # Y53TR - Landing Pad 1 # Y00221 You'd need a total of four of the...
  view full answer...
• Yakima Track Roof Rack Recommendation for Truck Bed Camper Shell
  We do offer the Yakima Control Towers # Y8890027 (you need 4) and Landing Pad 1 # Y00221 (you need 2) that will allow you to install Yakima round crossbars on a truck camper shell, but not using the older Q tower setup. For a 54 inch long track for the rack to install in you'll need the part # Y01127. Yakima round bars are available in many lengths. You may already have a set that will work too. 58-inch # Y00409 66-inch # Y00410 78-inch # Y00411
  view full answer...
• Can Roof Rack Tracks be Installed on A.R.E. Truck Cap
  Tracks can absolutely be installed on the roof of your A.R.E. Truck Cap to provide a mounting system for a roof rack. For this I recommend the Yakima Tracks, which come in 42 inch # Y01126, 54 inch # Y01127, and 60 inch # Y01135 lengths. These tracks are specifically designed for camper shells or truck caps like yours. To complete the setup you will just need the Landing Pad 1 # Y00221 (for which you will need a quantity of 2), 4 of the Yakima Control Tower part # Y8890027, and a set...
  view full answer...
  
• Solution for Transporting Kayak on 2017 Toyota Tacoma with Extang Encore Tonneau Cover Installed
  I have a couple possible solutions for you to transport your kayak with your 2017 Toyota Tacoma, however there is not a standard ladder rack available that is compatible with the Extang Encore Tonneau Cover. This is because the hardware for the Encore Tonneau Cover partially covers the top of the bed rails and any ladder rack will either require access to the inside of the bed rails or complete access to the stake pockets. The first option for your setup is to add a rail system and crossbars...
  view full answer...
• Can I Put Roof Top Tracks And A Roof Rack On My 1994 Chevrolet C/K 1500
  I do have a solution that may work for you. It would require you to check with your local body shop to see if it is safe to install roof top tracks on your vehicle. If it is deemed safe, the Rhino-Rack Aero Bar Roof Rack for Camper Shells - Track Mount - 54" Long, part # Y02-480B, will fit your 1994 Chevrolet 1500. It is a complete system that includes the roof top tracks and the roof rack. This is a low profile roof rack that has a weight capacity of 220 lbs, but I would suggest you...
  view full answer...
• Can I Cut the Tracks of the Rhino-Rack # Y02-480B Down to 50 Inches Long?
  Yes. You can cut the tracks on the Rhino-Rack Aero Bar Roof Rack for Camper Shells # Y02-480B to 50" long for installation. Although, this may require you to drill new holes in the tracks for the hardware. It is important to note that these tracks are compatible with hardtop resin roofs without headliners. However, if you are open to suggestions, I recommend using the following setup for your 2005 Jeep Wrangler: - Yakima JetStream Crossbars - Aluminum - Black - 50" Long # Y00425 - Yakima...
  view full answer...
• Can the Yakima 60 Track System Be Installed On Naked Roof Vehicles?
  You can use either the Yakima 54" tracks # Y01127 or 60" tracks # Y01135 on naked roofs without needing to remove the headliner, and as long as you're careful, you won't damage the headliner during installation. It should be noted that the 60" tracks are usually too long for most vehicles with naked roofs, which is why the title is so vague. The Yakima 54" kit comes with the PlusNut Hardware but to install the 60" tracks on a naked roof you would need to purchase a PlusNut Hardware kit...
  view full answer...
• Roof Rack Tracks & Crossbars For 2014 Dodge Grand Caravan
  So what you can do is install tracks on the top of your 2014 Dodge Grand Caravan and then install the roof rack system in those tracks. You'll need to measure to find the right length of tracks, as well as the correct crossbar width, but here's exactly what you'll need: - Yakima Tracks for Roof Racks - 42" Long # Y01126, 54" Long # Y01127, or 60" Long # Y01135 - Landing Pad 1 # Y00221 (You'll need to order Qty 2 of this part number) - SkyLine Towers for Yakima Crossbars # Y53TR - Yakima...
  view full answer...
• Will the Yakima Roof Tracks Fit a 2016 Ram 1500
  The Yakima Roof Tracks part # Y01126 for 42" long, part # Y01127 for 54" long, or part # Y01135 for 60" are universal tracks for a roof rack. They are not vehicle specific and will work on the majority of applications that space permits and the surface is relatively flat. On your 2016 Ram 1500 you could use them on the roof or bed rails. However, all of the tracks will require drilling so you will want to keep that in mind and you will also need to use the Replacement PlusNut Hardware...
  view full answer...
• Will The iKamper 2.0 Fit Yakima CrossBars
  According to iKamper's website, their product mounts to most cross bars due to its universal design, however since we do not carry their products I can not confirm this. With that being said, since they say it is universal, you can absolutely use the Flexible Track Rack System # Y01127, with the landing pads # Y00221, and the control towers # Y8890027 to mount the iKamper 2.0 on your 2008 Toyota Tundra. Depending how wide your roof is, you can use the 66" crossbars # Y00410, the 58"...
  view full answer...
• Are There Landing Pads Available To Mount Yakima Q-Towers To An A.R.E. Truck Topper
  I reached out to Yakima and was informed that there unfortunately is not a compatible landing pad for Q-Towers available so the only way to mount your Yakima crossbars would be to also get new towers. You would also need some tracks to mount on the roof of your A.R.E. Truck Topper to have something for the towers to mount to. We have the following track sizes available: 42" # Y01126 54" # Y01127 60" # Y01135 Since you have Q-Towers I'm assuming you have round bars and would need four...
  view full answer...
• Roof Rack Recommendation for 2014 Volvo XC60 Without Factory Roof Rails
  For your 2014 Volvo XC60 with naked roof, I recommend the Rhino-Rack Vortex Aero Roof Rack System. # RRVA126B-2 for the Vortex Aero Bars, # RRRLKVA the Rhino-Rack 2500 Series Legs, and # DK246 the custom-fit kit for the Volvo XC60. The Vortex Aero bar will provide for a quieter ride as well as a stylish low-profile look for your vehicle. I have attached an installation video of the Rhino-Rack Vortex Aero Rook Rack on a 2014 Volvo XC60 for you to review.
  view full answer...
• Temporary Roof Rack Solution Using Tracks on Bed Rails of 2012 Honda Ridgeline with OEM Tonneau
  There isn't a roof rack option specifically designed to mount on top of your bed rails and work together with the OEM tonneau cover on your 2012 Honda Ridgeline, so the closest option I have for you is going to be a Yakima Custom Install Roof Rack. To accomplish this, you'll need a set of SkyLine Towers (qty 4) # Y53TR, a pair of CoreBar Crossbars # Y00422, four total landing pads # Y00221 (sold in pairs), and 54 inch Tracks # Y01127. The Yakima Tracks, # Y01127, are designed for sheet...
  view full answer...
  
• Ladder Rack for a Leer Camper Shell on a 2007 Toyota Tundra
  We do have a camper shell ladder rack you can use with your Leer camper shell on your 2007 Toyota Tundra. take a look at the Thule TracRac CapRac # TH29200XT. This rack includes everything so it is ready to install. The load stops are also included. The bars are 65 inches long and the capacity is limited to the capacity of your Leer camper shell. If you would rather have a rack that is adjustable front to back then you can use Rhino-Rack roof rack # Y01-120-NTB with 54 inch long bars but...
  view full answer...
  
• Landing Pad Recommendation for Yakima Roof Tracks Y01127 for Installing 48 inch Round Crossbars
  The correct landing pad to go with the Tracks part # Y01127 is the Landing Pad 1 part # Y00221. Then for control towers you would need part # Y8890027 for individual towers, and then for 48 inch crossbars part # Y8810021.
  view full answer...
• Best Track System for a Roof Rack on a NuCamp T@G Camper
  Yes most of the T@G campers I have seen use the Yakima 54" Tracks for Roof Racks part # Y01127 base tracks. You can get evrything you need in one kit with the Yakima HardTop SL Roof Rack - 60" CoreBar Crossbars - 54" Tracks part # Y01618 . This has the tracks, bases, towers and bars for a complete set up. Happy Camping!!
  view full answer...

Do you have a question about this Roof Rack?