This clamp kit securely mounts a conduit carrier to your Rhino-Rack Vortex Aero crossbars. Clamps install in the top channels of your crossbars and are secured in place with bolts and nylon nuts.
Features:
Specs:
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Hey everyone, I'm Ellen 00:00:02 here at etrailer.com. And we're going to be taking a quick look at the Rhino Rack Vortex pipe clamps for your roof rack. So this allows you to have a nice spot to clamp any kind of conduit or pipe on your roof rack, without worrying about it slipping or sliding off.So they come with these two brackets that are just going to slide right into the T slot or that channel in your Vortex aero bars. And it also comes with a replacement in the rubber strip to go up top. So let's take a closer look and talk about what these will actually fit. So they're intended to go around a conduit that's up to four inches in diameter, comes with a bolt to tighten those down.
So these side pieces are just going to kind of slide and then twist into that slot in your aero bars and hold that in place.So you put these in there, put the conduit in, and then put the bolt and nut. the bolt through there. And then, tighten it down with the nut. You just need a 13 millimeter spanner to tighten everything down. And it does come with, again, replacement rubber to go in that aero bar.
And this is going to help to grip around the bottom side of the pipe or conduit or anything that you're holding. And make sure that it doesn't slip or slide. So you can tighten everything down, make sure that it's really nice and secure.This does have a weight capacity of 33 pounds. You do get two, so have one for the front bar, one for the back bar. And then again, your strips to go in place.
They are covered with a three-year warranty, and they're constructed of a rust-resistant galvanized steel. So it should be a pretty long lasting addition to your roof rack set up.That's pretty much all there is to it for our look at the Rhino Rack pipe clamps for your roof rack. I hope this has been helpful in the settings, if this is the right part for you. We do have a lot of Rhino Rack accessories as well as a lot of other roof-mounted accessories, and all kinds of good stuff here at etrailer.com. So check them out.
Thanks for watching.
Average Customer Rating: 5.0 out of 5 stars (1 Customer Reviews)
This clamp kit securely mounts a conduit carrier to your Rhino-Rack Vortex Aero crossbars. Clamps install in the top channels of your crossbars and are secured in place with bolts and nylon nuts.
Do you have a question about this Accessories and Part?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.