Summer Starts Here - Save up to 70%
Best 2010 Toyota Venza Trailer Hitch Options- Video
Speaker 1: Today we're going to be taking a look at the best hitch options for your 2010 Toyota Venza. Up top here we're going to have the Class 3 Draw-Tite. Right below that we're going to have the Class 3 CURT. Both of our hitches are going to look very similar. They're going to have minor differences but that could have a big impact on how you're going to use it. So let's take a closer look at some of the differences.One of the biggest difference is going to be the safety chain connection points. more
6/28/2018 11:02:11 AM
Trailer Hitch Installation - 2010 Toyota Venza - Curt- Video
Speaker 1: Today in our 2010 Toyota Venza, we're going to be taking a look at, and showing you how to install the Curt Class II Custom Fit Trailer Hitch Receiver, part number C12341. So, here's what our hitch is going to look like on the back of our Venza. It is going to sit right below the bumper and we are going to be able to see that cross tube. That is a class two hitch, which means it's going to give us an 1 1/4" by 1 1/4" receiver tube opening, and it is going to be pretty close to flush with our bumper, if not just a little bit back. So we're not going to have to worry about hitting our shin or our leg whenever we're walking behind our Venza. The way we're going to attach any of our accessories to our hitch, this is a hitch pin hole here on the side, and it comes with a 1/2" pin and clip, which is always a nice added bonus.And, since they are set back just a little bit from the hitch pin hole itself, we're not going to have to worry about any kind of interference with a locking device for the pinning clip itself. more
6/25/2018 3:57:24 PM
Trailer Hitch Installation - 2010 Toyota Venza - Curt 13356- Video
Today on our 2010 Toyota Venza, we're going to be installing the Curt Trailer Hitch Receiver, part number 13356. This is a class three rated hitch and does have a two inch opening in the receiver tube. Now we'll go ahead and give you a couple measurements in helping you choose some accessories for your hitch, such as a ball mount, a bicycle rack or a cargo carrier. From the center of the hitch pin hole to the outermost edge of the bumper is approximately 4 inches. From the top of the opening in the receiver to the ground is approximately 13 1/2 inches. Now let's go ahead and install our hitch. To begin our installation, we're going to start over here on the underside of the passenger side. more
1/8/2015 1:38:52 PM
