Summer Starts Here - Save up to 70%
Best 2012 Nissan Frontier Trailer Hitch Options- Video
Speaker 1: Today we're going to be taking a look at the best hitch options for your 2012 Nissan Frontier. Up top here we're going to have our Draw-Tite Class 3 hitch. Then right below that we're going to have our etrailer Class 3 hitch. Then finally, below that we're going to have our CURT Class 3 hitch.If I was looking for a hitch for my Frontier, I would probably go with the Draw-Tite for a few different reasons. It is going to have an increased tongue weight, which is going to be nice for a few different accessories we might want, or just to have your trailer, as well as some minor differences that it'll have over the two etrailer and the CURT. Let's take a closer look at all the differences between them.Our Draw-Tite is going to have the highest tongue weight at 750 pounds, and a gross trailer weight rating of 5,000 pounds. more
10/30/2018 10:17:37 AM
Trailer Hitch Installation - 2012 Nissan Frontier - Curt- Video
Today on this 2012 Nissan Frontier, were going to install part number 13241 from Curt. All right this is what the hitch looks once its installed on the vehicle. Next well give you some measurements that will help you out in selecting some accessories such as a ball mount, bicycle rack, or a cargo carrier. From the top of the receiver opening down to the ground will be about 18-3/4 and from the center of the hitch pin hole to the edge of the bumper will be around 3-1/4. Now well go ahead and show you how the hitch is installed.All right the first thing were going to do is go ahead and show you where the hitch will mount up to the frame. On each side of the frame close to the bumper will be three sets of threaded holes, well go ahead and point those out. more
3/14/2013 7:37:03 AM
Trailer Hitch Installation - 2012 Nissan Frontier - Draw-Tite- Video
Today in our 2012 Nissan Frontier, we'll be installing the draw tight hitch part number 75282. This is what our hitch will look like once it's installed. Now we'll go ahead and give you a couple of measurements to assist you in selecting accessories for your new hitch. From the center of the hitch, pin hole to the out most edge of the bumper is 3-1/2 inches. From the top of the receiver, tube to the ground is 17-1/2 inches. This will assist you in selecting accessories such as a draw bar, a bike rack or a cargo carrier. more
5/15/2012 4:04:41 PM
