Trailer Brake Controller Installation - 2012 Jeep Grand Cherokee- Video
Rate your transcript OrderClientKevin BrossRef #20497Order #TC0891082758 Today on our 2012 Jeep Grand Cherokee, we'll be installing our Tekonsha Prodigy P3 brake controller, part number 90195 with a direct fit wiring harness to connect directly to the manufacturer's brake controller port, part number 3045-P. Now, to begin the install of our new brake controller, on the driver side above the gas and brake pedal is a carpeted paneling that will need to be removed. To remove it, there are two push pin fasteners that will pry out that will release the carpeting, swing pull it out and set it aside for installation later. Next, above the emergency brake pedal, the white box is a grey plug. Grey plug will match the grey connector on the end of our new brake controller pigtail. We'll go ahead and put our grey plug on the pigtail into the grey socket on the manufacturer side. Now, once we push the connector into position and it locks in place, we'll go ahead and start the routing wires and securing it up underneath the dash. more
8/13/2014 12:50:06 PM
