2010 Honda CR-V Tow Bar Wiring Installation And Review Videos

Best 2010 Honda CR-V Tow Bar Wiring Options- Video

Speaker 1: Today we're going to be taking a look at the best tow bar wiring options for your 2010 Honda CR-V. Our tow bar wiring is going to be an essential part to our flat tow setup. It's going to take the signal from our motor home and transfer it to our CR-V, so whether we're stopping or changing lanes, everybody around us is going to know what's going on so we can get down the road safely.We're going to have three basic types of tow bar wiring. Over here we're going to have our diode style. In the middle we're going to have our bulb and socket. Then finally over here we're going to have our removable lights. more

6/19/2018 8:22:21 AM

Roadmaster Tail Light Wiring Kit Installation - 2010 Honda CR-V- Video

Today on our 2010 Honda CR-V, we'll be taking a look at and installing the Roadmaster tail light wiring kit with bulbs, part number RM-155. First thing we'll need to do in our installation of our Roadmaster tail light kit with bulbs is go ahead and open up our rear hatch to gain access to our tail light assemblies. Then, we will remove the caps located here and here on both sides. To remove the tail lights, use a small screwdriver to stick in the slot and pop it out. Once you've popped out both the caps, repeat that same process on the passenger side. Anything we do here on the driver side, as far as the removal and re-installation of the tail lights, is going to be repeated on that passenger side. All right. Now, we're going to remove the two bolts on the inside. more

11/6/2015 2:08:00 PM

Hopkins Tail Light Wiring Harness Installation - 2010 Honda CR-V- Video

All right, today on this 2010 Honda CR-V, we're going to show you the Hopkins Custom Tail Light Wiring Kit for Towed Vehicles, part number HM56300. These are the parts that you get with the kit. This is actually a t-connector style electrical harness, so this will fit in between two connection points on your vehicle. In this case, the t-connection with the green wire will go to the passenger side. The one with the yellow will go to the driver side. We'll take a look. This is our diode converter here, and this will take the signals from the RV and send it out to your tail lights. more

9/15/2015 12:47:02 PM