Best 2012 Buick Enclave Tow Bar Wiring Options- Video
Today on our 2012 Buick Enclave, we will be completing a flat tow setup using Roadmaster's EZ crossbar-style baseplate, Roadmaster's Falcon 2 tow bar, Roadmaster's 68" single-hook coiled safety cables, Roadmaster's diode seven-wire to six-wire Flexo-Coil wiring kit, Roadmaster's FuseMaster fuse bypass switch for towed vehicles, Roadmaster's stoplight switch kit for the Buick Enclaves, Roadmaster's BrakeMaster system, this is for RVs with air or air over hydraulic brakes, and Roadmaster's BrakeMaster custom seat adapter for Buick Enclaves. If your RV doesn't have air brakes and has conventional brakes, you might want to look into SMI's Stay-IN-Play DUO, as that's one of the best systems out there for non-air brakes.This is what our Buick Enclave is going to look like when it's all set up and ready to flat tow. The baseplate itself is the interface that allows tow bars and safety cables to connect to, to properly tow your vehicle behind your motor home. With everything disconnected, it'll be relatively hidden behind your bumper. This is what our baseplate's going to look like when it's installed. We've got our fascia off so we can show you the attachment points. more
1/28/2019 11:45:07 AM
Roadmaster Fuse Bypass Switch for Towed Vehicles Installation - 2012 Buick Enclave- Video
All right today in this 2012 Buick Enclave we're going to install part number RM76513. This is a Roadmaster FuseMaster Fuse Bypass Switch for towed vehicles. All right. To start off our install, we'll need to get this new harness ready to go. First we'll go ahead and remove the 2-amp fuse in the small fuse holder on the ground wire. Next we'll go to the vehicle's owners manual and determine which fuse must be remove for towing. more
11/25/2014 10:19:07 AM
Roadmaster Tow Bar Wiring Kit Installation - 2012 Buick Enclave- Video
Today on the 2012 Buick Enclave, we'll be installing the Road Master Universal High Powered Diode Wiring Kit, part number RM-154. We'll begin here at the rear of the vehicle, as we'll go ahead and raise the rear hatch up, we're going to need to remove each of the tail light assemblies. We'll go ahead and pull these 2 little black tabs up using a small flat head screwdriver and then underneath, there will be a screw underneath each cover. Go ahead and remove each of the 2 screws. Then, we can gently pull out on a tail light assembly. We'll need to disconnect the factory wiring from the back side. more
4/23/2014 11:16:35 AM
