Yakima Control Tower Roof Rack Installation - 2013 Mazda 3- Video
Today on our 2013 Mazda3. We'll be test fitting the Yakuma control tower roof rack system using the 48 inch round bars. Part number Y00408 Y00214 and two sets of Y00233. With our roof rack system assembled according to the manufactures instruction. We'll begin our test fit by removing the black plastic cover over our fix mounting points. We'll then place our landing pads over our fix mounting points, and secure them through the car using an Allen bolt. We'll do this on all four locations, and give them a shake to make sure they're secured. more
3/19/2014 12:54:30 PM
Whispbar Through Bar Roof Rack Installation - 2013 Mazda 3- Video
Today on our 2014 Ford Expedition, we're going to be test fitting the Swagman Titan, a tilting 4-bike rack for 1-1/4" and 2" hitches, part number S63410. To begin our test fit, we'll slide the shank of the bike rack into the receiver tube of our hitch. We'll line up the pin holes, thread in our anti-rattle bolt, and tighten it down with our wrench. In this position, you'll have about 21" worth of ground clearance. The closest point of the rack to the back to the back of our Expedition is about 5-1/2", and overall we've added about 20-1/2" to the length of the vehicle. Pulling the black lever at the base of the mast will allow us to tilt it away from our Expedition. As you can see, this does give us full access into our rear hatch. more
3/18/2014 5:14:51 PM
Thule Podium Roof Rack Installation - 2013 Mazda 3- Video
Today on our 2013 Mazda 3, we're going to be test fitting the Thule Podium roof rack system, part numbers THLB50, TH460, THKIT3069. We'll begin our test fit by removing the black covers over our fixed mounting points on our Mazda 3. We'll then thread in our threaded bolts, tighten them down with the supplied Allen key, and install our sleeves so they're resting on top of our vehicle and not the black trim piece. Now with our Thule Podium rack system assembled according to the manufacturer's instructions, we'll now slide our foot packs over our sleeves, then check and make sure we have even overhang on both sides. We'll grab our rear bar and repeat that same process. With our bars installed and even overhang on both sides, we'll now take the hex nuts and thread them down over our threaded bolts. We'll then tighten these down with a wrench to get a secure fit. Now, it's time to lock our bars into place. more
3/17/2014 2:24:11 PM
Thule AeroBlade Podium Roof Rack Installation - 2013 Mazda 3- Video
Today on our 2013 Mazda 3 well be test fitting the Thule AeroBlade Roof Rack System using the Thule AeroBlade Load Bars at 47 inches part number THARB47, the Thule Podium Foot Pack for Aero Bars part number TH460R and the Thule Fit Kit for podium style foot packs part number THKIT3069. To begin our test fit well remove the protective covers over the fixed mounting points on our vehicle. Now well go ahead and install the roof studs threading them into place and tightening them down with the included 3-mm Allen key. We already have our bars assembled according to the instruction, so were ready to place them on top of our roof. Well go ahead and take our front load bar and place it on the front part of our roof. We want to make sure that our roof studs go through our foot pack. more
7/7/2013 6:19:01 AM
