Yakima Q Tower Roof Rack Installation - 2012 Dodge Charger- Video
Today on our 2012 Dodge Charger we'll be test fitting the Yakima Round Bar Roof Racking System, part numbers y00409, y00699, y00683 and y00124. Now with our crossbars, towers, and Q-clips already assembled according to the instructions we'll begin our test fit by placing the front crossbar onto the front of the vehicle. We'll measure from the first part of the glass to the first part of the tower.According the instructions this measurement is eight inches. We'll do this on both the passenger side and driver's side of the vehicle making sure that the pads will contour to the roof of our vehicle correctly. Once we've established this position onto our charger we'll turn the silver bolt on the inside of the tower and clamp down the black levers securing the front crossbar to the vehicle.We'll now set our rear crossbar onto the roof of our charger and measure our crossbar spread. The crossbar spread is the measurement from the center of the front crossbar to the center of the rear crossbar and this measurement is 32 inches. more
6/17/2013 8:35:24 AM
Thule Traverse Roof Rack Installation - 2012 Dodge Charger- Video
All right today on this 2012 Dodge Charger, we're going to do a test fit of the Thule Roof Rack System. We'll be using the Thule Square Load Bar, part number THLB58, part number TH480, the traverse flip pack and part number THKIT1604 Thule fit kit. Now we're going to start off our load bars already assembled according to instructions, so all we got to do is put them on the roof. We'll start with the front crossbar and open up the front doors and then place the bar onto the roof. To place the bar correctly, we'll measure from the edge of the windshield to the edge of the foot pack. I always go by the instructions, but on this particular test fit, we'll be using a measurement of eight and a quarter inches. more
6/6/2012 1:10:07 PM
