Rhino Rack MountainTrail Roof Bike Racks Review - 2010 Chevrolet Cobalt- Video
Today on this 2010 Chevrolet Cobalt we're going to be test fitting the Rhino Rack Mountain Trail Bike Rack. Part number RVC035. As you can see we already have the bike attached to the rack, let's go ahead and take a closer look. Now, it's actually attached to the rack, you're going to have two points of contact. We're going to have the strap here that holds the rear wheel in place, then we have the fork mount up front with the skewer that holds the front in place. Now, the skewer is lockable so once this is installed you can lock it in place so no one can take your bike. Let's go ahead and take the bike off and set it aside. To loosen up the strap back here you simply push in on this button here, pull the strap out. more
2/29/2016 9:26:56 AM
Yakima ForkLift Roof Mounted Bike Rack Review - 2010 Chevrolet Cobalt- Video
Today on our 2010 Chevy Cobalt, well be test fitting the Yakima Forklift Roof Mounted Bike Carrier, part number Y02098.Now to begin our test fit, we'll set the carrier onto the vehicles crossbars. We'll move to the front of the carrier where we'll loosen up the front bracket and bring it around the underside of the front crossbar. We'll loosen up the black wing nut to allow us to do this.We'll then move to the rear of the carrier where we will again loosen up the black wing nut, bring the bracket around the rear of the crossbar. We'll then tighten down the black wing nut to secure the rear of the carrier to the vehicles rear crossbar.We will then move back up to the front of the vehicle, where we will loosen up the skewer. The skewer of this carrier does have reverse threads. After removing the skewer, itll allow us to slide the black cap back to have access to the wing nut. more
3/20/2013 2:59:31 PM
RockyMounts TieRod Roof Bike Rack Review - 2009 Chevrolet Cobalt- Video
Today on our 2009 Chevrolet Cobalt Two-Door, we'll be test fitting the RockyMounts TieRod Roof Mounted Bike Carrier, part number RKY1014. We'll take our carrier and set it up on top of our crossbars. At the front, we want to make sure to fit the head properly over the front crossbar and feed the straps around the bar. We'll fit them back into the head and use the Allen key to tighten them down. We'll then reinstall our cover and then make sure that the skewer is open. At the rear of the carrier, we'll fit our clamp around the bar and use the wing nuts to tighten it down. more
10/19/2012 1:38:41 PM
Filter Videos
Filter Videos
