TracRac Pro2 Truck Bed Ladder Rack Installation - 2013 Ford F-250- Video
Today on a 2013 Ford F-250 Super Duty, we're going to install part number TA37003. This is a TracRac Pro 2 Truck Bed Ladder Rack Systemn for Super Duty pick-ups. One thing about our TracRac here is this actually will fit for a variety of vehicles. So to start off we already have our bars put together; one good tip, really good while you put in together is actually get a measurement, from the inside edge where you going to roughly put it to the other side edge. Put that on the garage or floor, and then build it up to that measurement then you can go ahead and put it on your truck. With that out of the way, let's go ahead and put our pads on in the place. For these they may go underneath for TracRac. What I'm doing is I am actually putting on the edge of the pad right up to the edge of the rail here. We found out that on testing in that we have to scoot it back enough to get enough room for our clamps. So let's have a certain amount of space. So let's put one on each side. Let us go ahead put our first TracRac in to place. We got to passenger side sitting in the place. Well just squeeze the driver's side in just a little bit. Make sure it's square with the truck. Now and go ahead and put our clamps in the place. more
10/20/2014 11:13:13 AM
TracRac T-Rac G2 Truck Bed Ladder Rack Installation - 2013 Ford F-250- Video
Today on our 2013 Ford F250, well be test fitting the Tracrac T-Rac G2 Truck Bed Ladder Rack for Ford Super Duty and Dodge Ram rated at 800 rounds, part number TA30000-03. With everything all assembled according to the included instructions, well begin or test fit by placing the front part of the ladder rack onto the front of our truck bed. Here at the cab you want to make sure that the feet, which rest along the bed rails, are facing the tailgate of the pickup truck. With the front part of the rack in place we can then measure the over hung of the top bar making sure it is equal on both sides. Once weve established this measurement, we can then tighten down the bolts using the included on wrench to secure the upright mass in place. Now with this down we can use the C clamps, which we will insert the bolt through the bottom of the C clamp as well as a silver bracket, which will rest on the underside of the bed rail. Well place the C clamps into the channels on the bottom part of the rack, which rests on the bed rail. more
9/4/2013 12:10:55 PM
