B&W 5th Wheel Trailer Hitch Installation - 2013 GMC Sierra- Video
On this 2013 GMC Sierra, we're going to review and install the custom under bed insulation kit from B&W Companion Fith Wheel Trailer Hitches, Part Number BWGNRK-1012-5W. This is what the hitch looks like once installed on our Sierra. Now aside from drilling into the bed of course to install our hitch, for everything else there's no drilling required to install the frame brackets to the frame. It uses two existing holes in the frame and comes complete with all the hardware necessary to install. This is our handle right here, which is used to operate the pin when you need to use it. Now the hitch has a gross towing limit of 30,000 pounds and a vertical load limit 7,500 pounds. Now always double check your owner's manual or your vehicle to make sure it can handle these kinds of weights. more
12/1/2015 3:21:06 PM
Fifth Wheel Installation - 2013 GMC Sierra- Video
Today on our 2013 GMC Sierra short-bed, we'll be installing the under-bed rail and installation for Reese Elite Series 5th wheel trailer hitches, part number Rp30868. Now, we've already gone ahead and removed the spare tire and the spare tire shield from the vehicle. We've also gone ahead and removed the heat shield bolts as they are a little hard to get out. They are loctited in so you may need to cut them out depending on the age of the vehicle. We're now going to go ahead and remove our heat shield. We don't want to take it all down, so we're going to go ahead and cut it. The bolt here on the bed is not easily accessible. We'll go ahead and cut the shield around the bolt. more
10/16/2014 10:25:56 AM
Curt Fifth Wheel Installation - 2013 GMC Sierra- Video
All right today on this 2013 GMC Sierra we are going to install part number CI6413-204, this is a Curt custom fifth wheel installation kit. First off all well measure out from the edge of the tailgate as described in the instructions. Always go by you measurements but in this case we use the measurement of 52 and three eighths inches. Well go ahead and mark the location on the left and right sides of the bed and then well put a rail up to our marks. Then well make sure its even left to right. Then well go ahead and mark out the holes we are going to use to mount to the frame brackets. more
12/15/2013 9:13:41 PM
