B&W Fifth Wheel Trailer Hitch Installation - 2007 Chevrolet Silverado New Body- Video
All right. Today, in this 2007 Chevrolet Silverado New Body Extended Cab, we'll be installing part number BWGNRK1057-5W. The custom underbed installation kit for B & W companion 5th Wheel Trailer hitches. First, we'll show you how the B & W 5th Wheel Companion works. First, we'll pull up the locking pin on the side of the truck and twist it towards the front the truck. That the pin stays open. more
5/20/2014 10:48:08 AM
Fifth Wheel Base Rail Kit Installation - 2007 Chevy Silverado- Video
Today on this 2007 Chevrolet Silverado we are going to install part number RP50064-58. Alright, while we are under the truck we will go ahead and remove this section of the heat shield because we are going to need wrench access for the bolts that come down for the second rail. After that, we will go ahead and start with the bed itself and measure out our first rail that will get installed in the bed. That will be the rail going towards the front. What we are going to do is measure from the edge of the bed itself and measure out as described in the instructions. Alright, that will set our distance from front to rear. Now we will just get it centered from left to right. We just measure from the inside edge of the fender well over to the rail. Go ahead and mark the holes that we are going to be drilling out through the bed. And on this kit we are going to be using the two outside holes here on this rail. Alright with the marks we made we will go ahead and drill out some pilot holes. When you are drilling out this hole, make sure you are careful about it because beneath here is where the gas tank lies. 0:57 more
4/11/2011 12:07:00 AM
Fifth Wheel Hitch Installation - 2007 Chevy Silverado- Video
Today we are going to be installing the Signature Series Fifth Wheel part number 30061. On a 2007 new body style Chevy Silverado pickup 2500. The first thing we need to do is lower the spare tire to gain access to the under body. Next we will need to remove the heat shield or else it will be in the way during our installation. After we remove the heat shield we want to go ahead and put the rear cross member into place. As you can clearly see that we have already put the cross member in. It will be easier if you loosen or remove the bed bolts. There are 4 middle ones that if you take them out or loosen they will allow you extra room when putting the cross member back into position. Then go ahead and install the front and rear channel. You can see we have both cross members into position now. The next step will be to mount the side brackets on the side of the frame. more
8/14/2009 10:28:20 AM
Filter Videos
Filter Videos
