Best 2011 Toyota RAV4 Trailer Wiring Options- Video
Today we're going to be taking a look at the best trailer wiring harnesses available for the 2011 Toyota RAV4. We've got two different kits to look at today. Here we've got our Curt, this is part number C56165. Of course, just like our Tekonsha this is going to give us a four pole flat trailer connector which is going to deliver our right turn and brake, our left turn and brake, our running lights, and our ground for our trailer or cargo carrier, whatever we decide to operate. Here we have a very similar kit. This is the Tekonsha T-1 Vehicle Wiring Harness. more
1/4/2017 2:38:31 PM
Trailer Wiring Harness Installation - 2011 Toyota RAV4- Video
Today in our 2011 Toyota RAV4, well be installing the Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector, part number C56165. Well go ahead and start here by opening up the rear hatch of the vehicle. Well first need to go ahead and remove this carpet here in the rear cargo area. Well then go ahead and take out this cover. We need to go ahead and remove this cover right here as well as this door right here. To do this door, you simply push in on both tabs, and gently pull outward. more
2/24/2014 2:23:07 PM
Trailer Wiring Harness Installation - 2011 Toyota RAV4 118412- Video
Today on this 2011 Toyota Rav4, were going to install part number 118412 from Tow Ready. First thing we are going to do is open up the back of the vehicle and get to the interior, we have to remove the threshold and the four coverings. Were also going to loosen up the side panels as well, there will be three fasteners that we have to remove, there will be two bolts and one bolt for the tie down point towards the bottom, and then well use a trim panel tool to help pop the sides away from the body. All right now well go ahead and look for our connection points, the connections points are going to be right behind the taillights, with the small tab we can push so we can remove the connector to the taillight, well put it out here and Ill take it apart and show you where the tab is push down. All right now well go ahead and start installing our T-connector, starting with the T-connector with the yellow wire well plug it into the factory wire harness, well compare them two and put them together and well take the other half and push it back into the taillight. Well take the other T-connector with the green wire and well run it in behind the plastic and over to the other side, well slip it behind the plastic and run it up to the taillight just like we did on the driver side. more
1/15/2013 9:55:51 AM
