Best 2011 Toyota Highlander Trailer Wiring Options- Video
Today we're going to be taking a look at the best wiring options for your 2011 Toyota Highlander. First we've got our CURT customer vehicle wiring harness, part number C56217. Then we've got our Tekonsha T1 vehicle wiring harness, part number 118449. Lastly we've got our CURT customer vehicle wiring harness, part number 56042. The first obvious difference that we're going to see here is that with this wiring harness over here this CURT does not have as much as the others. That's because if you have a Highlander that already has the tow package with the conveter mounted underneath the dash, this is all that you're going to need. But, if you don't, then one of these other two kits will be the right fit for you. The first difference that we're going to look at between the CURT and the Tekonsha wiring harnesses is the amperage rating on each circuit. more
11/9/2016 4:11:41 PM
Trailer Wiring Harness Installation - 2011 Toyota Highlander- Video
Rate your transcript OrderClientKevin BrossRef #20618Order #TC0717467062 Today, in our 2011 Toyota Highlander, well be installing the Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Connector, part number C56217. To begin our install, first well need to gain access to the port. To do that, well go ahead and open up the rear hatch. Well go ahead and remove the center cargo cover, storage compartment door, trim paneling or floor paneling here on the driver side, the rear shade or the rear visor cargo cover. Now, we need to remove the storage compartment here on the driver side. There are three fasteners, one push-in fasteners and two plastic caps here in the bottom of the storage compartment. Were now ready to remove the corner compartment. more
8/16/2014 2:46:09 PM
Trailer Wiring Harness Installation - 2011 Toyota Highlander 118449- Video
Today on this 2011 Toyota Highlander we are going to install part number 118449 from Tow Ready. This kit comes with a few different pieces. It comes with a fuse that goes into the fuse holder underneath the hood. The module itself actually gets plugged underneath the dash of the vehicle. The 4-pole flat is actually plugged into a port that is at the rear of the vehicle. So we will start at the front and work our way back. The first thing we need to do is go ahead and get underneath the dash and we will go ahead and plug in the module in to its port. OK, this is the module itself. And this is the part that gets plugged in to the port underneath the dash. In this particular case, it is pretty easy to find. It stands right out. Just kind of pull it down a little bit and plug in to it. Now we will take our module box. It has an adhesive back to it. It will actually mount to this component above it in a nice, flat spot. 0:55 more
5/16/2011 12:29:39 AM
