bing tracking image

2012 Kia Sedona Custom Fit Vehicle Wiring Installation And Review Videos

     

Best 2012 Kia Sedona Trailer Wiring Options- Video

Best 2012 Kia Sedona Trailer Wiring Options

Today we're going to be taking a look at the best wiring options for your 2012 Kia Sedona. Up top we've got the Tekonsha T1 Vehicle Wiring Harness with 4 pull flat trailer connector, part number 118410. Next we've got the Curt T Connector Vehicle Wiring Harness with 4 pull flat trailer connector, part number is C55503. Finally, we've got the Hopkins Simple Plug-In Vehicle Wiring Harness with 4 pull flat trailer connector, part number HM11143955. The biggest difference that we're going to see between these wiring harnesses is that on the Curt and Hopkins, they're going to have about a foot longer 4 pull wiring then on the Tekonsha. That's going to help in towing situations to where you may need a little but extra wire. On the Hopkins, here, the last few feet of wire, coming out towards the 4 pull plug, come pre-wrapped to help protect it from any possible heat or rubbing on the ground or trailer. When we look at the module boxes on these wiring harnesses, the Hopkins is going to have the largest module box, then, a little bit smaller than that is the Curt, and the smallest of the three is going to be here, on the Tekonsha. more


Watch Video

10/28/2016 8:58:54 AM



Trailer Wiring Harness Installation - 2012 Kia Sedona- Video

Trailer Wiring Harness Installation - 2012 Kia Sedona

Today our 2012 Kia Sedona. Were going to review and install the Curt T connector wiring harness with 4 pole trailer connector. Part number C55503. Once you have the rear hatch open, locate the tail light assemblies. They're going to be the same on the driver and the passenger side. With three Phillips head screws that we're going to need to remove to pull out the tail light assembly and locate the manufacture wiring harness. more


Watch Video

9/25/2015 10:01:06 AM



Trailer Wiring Harness Installation - 2012 Kia Sedona 118410- Video

Trailer Wiring Harness Installation - 2012 Kia Sedona 118410

Today, on this 2012 Kia Sedona, we're going to install part number 118410 from Tow Ready. First thing we need to do is go ahead and open the tail gate and get access to the tail lights to remove both of them. They'll be three screws in each light, so to remove the tail light you will pry the light away from the vehicle. We'll disconnect the wire harness from the tail light. There will be a small tab that you have to push down and then we can go ahead and release the light from the wire harness. Next, we will go ahead and take the four pole wire and run it down between the bumper cover and the body of the vehicle. more


Watch Video

12/3/2012 8:27:55 AM



  1