bing tracking image

2012 Jeep Wrangler Custom Fit Vehicle Wiring Installation And Review Videos

     

Best 2012 Jeep Wrangler Trailer Wiring Options- Video

Best 2012 Jeep Wrangler Trailer Wiring Options

Today on our 2012 Jeep Wrangler we're going to be taking a look at the best wiring options available. The three wiring options we're going to be taking a look at, well first off with the Tekonsha, that's going to be part number 118416. The middle one here is going to be our Hopkins, and that's part number HM42635. Then last one here is going to be our CURT, part number C55124. All of our wiring harnesses are going to be great for towing a single axle trailer with two lights on the back and maybe some side marker lights. All of our wiring harness are very easy to install. They just plug inline behind our driver side taillight. more


Watch Video

2/28/2017 12:38:21 PM



Trailer Wiring Harness Installation - 2012 Jeep Wrangler- Video

Trailer Wiring Harness Installation - 2012 Jeep Wrangler

Today on our 2012 Jeep Wrangler we're going to be installing the CURT t-connector vehicle wiring harness, part number C55124. Now we're going to begin over here on the driver side taillight. We're going to need to remove the four screws that secure the taillight to the vehicle. To remove them we'll be using a Phillips head screwdriver. We'll then slide the taillight assembly out from the body. You'll notice that there's a couple tabs here on the backside that help hold it in place. We're then going to need to disconnect the factory wiring from the backside of the taillight. more


Watch Video

9/25/2014 6:58:24 PM



Trailer Wiring Harness Installation - 2012 Jeep Wrangler 118416- Video

Trailer Wiring Harness Installation - 2012 Jeep Wrangler 118416

Alright, today on this 2012 Jeep Wrangler were going to install part number 118416 from Tow Ready. First thing we need to do is go ahead and remove the tail light. And then we'll go ahead disconnect our tail light right here, push down on this tab and it should come right apart. Alright, now we'll take our T1 harness, we're going to take the 4-pole and rout it inside the body for now. And then we'll test the matching in of our T1 connector to the factory wire harness and snap it together. Alright now were going to take our white wire with the ring terminal, peel this back a little bit and run it down outside to the frame for our ground point. more


Watch Video

2/14/2012 10:26:19 AM



  1