Best 2004 Jeep Wrangler Trailer Wiring Options- Video
Speaker 1: Today we're going to be taking a look at the best custom fit vehicle wiring for your 2004 Jeep Wrangler. Here on your left we're going to have the Tekonsha, part number 118409. Here in the center we're going to have the Hopkins, part number 42615. Then here on your right side we're going to have the CURT, part number 55363.Now what any one of these wiring harnesses are going to do for you, it's going to give you the proper lighting functions not only legally but safely tow a trailer or any of your favorite hitch-mounted accessories that may require lighting.Let's talk a little bit about how these install. With our Tekonsha and our CURT, you're going to have two sets of wires, yellow and green. One's going to go over to the driver side. more
10/24/2018 3:07:12 PM
Trailer Wiring Harness Installation - 2004 Jeep Wrangler- Video
Today on our 2004 Jeep Wrangler, we'll be installing the Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector, part number C55363. Now, to begin our install, we'll first go underneath the driver side taillight assembly and locate the plastic cover that covers up the rear portion of the body. Once we locate the plastic flap, we'll need to peel it back, but before we do that, there's a push-pin fastener that need to pulled. You can use a flat-blade screw driver or plastic trim panel tool just to pry that plastic fastener out, and we'll pull a bit down on the flap. Once we have it down, we can expose the manufacturer's electrical connector here and note that it sometimes can be wrapped in foam to help protect it from the outside elements. Since this one's already been removed, we're going to press on the connector lock and separate the two connectors. There it goes. more
11/20/2014 11:45:33 AM
Trailer Wiring Harness Installation - 2004 Jeep Wrangler 118409- Video
Today on this 2004 Jeep Wrangler we will be installing wiring harness part number 118409. We are underneath the Wrangler here, we are actually directly under the tail-light assembly underneath the car. The ports that we are going to be looking for to plug our harness into are located up above this rubber covering here. So we need to pull this back to gain access to the port. You can see we have one push pin here that is holding it into place, so we need to release that first. more
9/22/2009 9:45:44 AM
