2008 Jeep Liberty Trailer Wiring Options- Video
Speaker 1: Today we're going to be taken a look at the best custom fit vehicle wiring harness for your 2008 Jeep Liberty. Here we're going to have the best three wiring harnesses for your vehicle. Over here on the left we're going to have the Hopkins. Here in the middle we're going to have Techoncha. And over here on the right we're going to have the Curt.Your Curt is going to have a six amp per circuit for your tail lights and a three amp per circuit for your stop and turn. Whereas your Techoncha is going to have a 5.6 amp for your tail lights and a 2.1 amp for your stop and turn. more
2/14/2018 5:22:10 PM
Trailer Wiring Harness Installation - 2008 Jeep Liberty- Video
Today on our 2008 Jeep Liberty, we're going to be taking a look at and installing the Tow Ready T1 Vehicle Wiring Harness, part number 118554. Now here's what it's going to look like once it's installed. It gives you nice four flat wiring with their weather tight cover. When you're not using it, you can just wrap it around your safety chain link. Now it'll stay there and won't be dangling around the bottom of your vehicle. It's not going to require you to have to cut any wires, tap into any wires, which is going to help save your electrical system. Now we're going to take the liberty to show you what's going to be included in your kit. You're going to have your T1 connectors, your module light which is going to go into your four flat with their weather tight connector, our hardware package, our fuse holder, and our 12-volt wire that's going to run from the battery to the back of the car and tie under our module light. Now let's go ahead and show you how to install it. more
4/27/2016 10:06:39 AM
Trailer Wiring Harness Installation - 2008 Jeep Liberty C56183- Video
Today in our 2008 Jeep Liberty, we'll be installing the CURT T-connector Wiring Harness with 4-Pole Flat Trailer Connection, part number C56183. To begin our install, we'll first open up the rear hatch. There are two screws for each assembly. We'll go ahead and remove the screws and then pop the assembly out of its position being careful not to break the alignment tabs underneath. Then, we'll go ahead and press on the wiring connector and remove it from the taillight socket, setting the taillight aside. Now with the driver side done, I'll go ahead and repeat the same process on the passenger side. Next, we'll take our new CURT wiring harness and feed the green wire connector down between the bumper cover and body or sheet metal of the vehicle. more
11/25/2013 7:32:53 AM
