Best 2012 Jeep Compass Trailer Wiring Options- Video
Speaker 1: Today we're going to be taking a look at the best custom fit vehicle wiring harness for your 2012 Jeep Compass. Here we have the two best custom fit vehicle wiring harnesses for your Jeep Compass. Here on your left we're going to have the Tekonsha, part number 118539. Here on your right we're going to have the CURT, part number C56344. Let's go over some of the differences between these two.One of the big noticeable differences we're going to see here is going to be the size of our converter box. You can see our CURT box is a little bit bigger, which means it may be a little bit more difficult or you may be limited on certain places that you can place this one, where your Tekonsha, it looks pretty small so you can just about fit that one anywhere.Another difference is going to be how our wires run up to our plugs. more
8/31/2018 3:57:12 PM
Curt Trailer Wiring Harness Installation - 2012 Jeep Compass- Video
Today on our 2012 Jeep Compass well be installing a Curt tee connector vehicle wire harness with four poll flat connector, part number C56129. To begin our install well first open up the rear hatch and then well need to remove the rear taillight assemblies. Starting here on the drivers side, well go ahead and remove the two fasteners that secure the rear taillight assembly. To remove the fasteners well use a flat blade screwdriver and pry out on the center section and then remove the entire piece. Note: This is a two piece fastener so the center section can be completely out and then remove the second half. Now with the fasteners out of the way we will go head and gently pop the rear taillight lens towards the rear of the vehicle releasing the fasteners underneath, here and here. more
10/22/2013 9:42:10 AM
Trailer Wiring Harness Installation - 2012 Jeep Compass- Video
Today, on this 2012 Jeep Compass, we're going to install part number 118539 from Tow Ready. The first thing we'll do is go ahead and open the tail gate and we need to remove the tail lights. We have to remove the two plastic rivets. we'll get started with a screw driver and then we can use a trim tool to remove them. Then we'll disconnect the latch core harness, push down the tab right here and push down here and we should be able to disconnect it. Alright, we'll do the same process over on the passenger's side. more
4/2/2012 4:01:22 PM
