2014 Hyundai Tucson Custom Fit Vehicle Wiring Installation And Review Videos

Installation Guide for the Tekonsha T-One Vehicle Wiring Harness - 2014 Hyundai Tucson- Video

Howdy, neighbors. This is Ian with etrailer here. We've got the Tekonsha four-pole that we're gonna be installing today, so let's get into it. With this Tekonsha four-pole harness, this is gonna allow you to hook up to any trailer that's gonna have your running lights, turn signals, or brake lights. It also will work with any cargo carrier that's gonna have the same four-pole wiring as well. This harness is great because you're gonna be able to tuck this away when you need to just have it gone. more

5/20/2024 9:02:28 AM

Best 2014 Hyundai Tucson Trailer Wiring Options- Video

Speaker 1: Today we're going to be looking at the best wiring options for our 2014 Hyundai Tucson. Here we have our wiring from CURT and here we have our wiring from Tekonsha. They're both going to perform similar functions for your vehicle, and for the most part they're very similar, but there are a few differences between them.The biggest differences between these two harnesses are going to be how it's installed and where your four-pole connector's going to be located. With your Tekonsha it's going to live inside the vehicle, so when you need to use it you'll have to pull it out from your storage compartment, drape it over the back, hook it up to your trailer. When you shut it, you do want to make sure you don't come into contact with the latch here. Otherwise, it's okay. more

5/7/2018 3:42:33 PM

Trailer Wiring Harness Installation - 2014 Hyundai Tuscon- Video

Today on our 2014 Hyundai Tucson, we'll be installing the Curt T-connector vehicle wiring harness with a 4-pole flat trailer connector, part number 56101. First, we'll open up the rear hatch. Then, starting on the driver side, we'll remove the two fasteners that secure the tail light housing. Remove the fasteners and then we're going to go ahead and pop the tail light housing free. Be careful not to break the alignment tabs underneath. Now, we can disconnect the manufacturers wiring that goes into the back of the tail light assembly, removing the connector from the socket. To do that, we'll press on the locking tab, removing the connector. Then, we'll go ahead and set tail light assembly aside. more

5/28/2014 2:06:34 PM