bing tracking image

2010 Hyundai Tucson Custom Fit Vehicle Wiring Installation And Review Videos

     

Best 2010 Hyundai Tucson Trailer Wiring Options- Video

Best 2010 Hyundai Tucson Trailer Wiring Options

Speaker 1: Today we're going to be looking at the best wiring options for our 2010 Hyundai Tucson. Here we have our wiring from CURT and here we have our wiring from Tekonsha. They're both going to perform similar functions for your vehicle, and for the most part they're very similar, but there are a few differences between them.The biggest differences between these two harnesses are going to be how it's installed and where your four-pole connector's going to be located. With your Tekonsha it's going to live inside the vehicle, so when you need to use it you'll have to pull it out from your storage compartment, drape it over the back, hook it up to your trailer. When you shut it, you do want to make sure you don't come into contact with the latch here. Otherwise, it's okay. more


Watch Video

4/26/2018 2:22:11 PM



Trailer Wiring Harness Installation - 2010 Hyundai Tucson- Video

Trailer Wiring Harness Installation - 2010 Hyundai Tucson

Today on our 2010 Hyundai Tucson we'll be installing the tow-ready T1 four flat wiring connector, part number 118501. To begin with we will need to raise the rear hatch. Once we have that up we'll need to remove both of the tail light assemblies. To do this you'll need to remove two Philips head screws from each of the light assemblies. Once the two screws are out pull gently outward on the light assembly towards the back of the vehicle and it should release from its two other tabs that are behind the light. Once you have it out we'll go ahead and squeeze the wiring connector and pull it apart. Be careful when doing this so you don't break the locking tab. Now that we have both light assemblies disconnected we can set them aside for right now. more


Watch Video

7/15/2013 5:53:19 AM



  1