bing tracking image

2012 Honda Accord Custom Fit Vehicle Wiring Installation And Review Videos

     

Best 2012 Honda Accord Trailer Wiring Harness Options- Video

Best 2012 Honda Accord Trailer Wiring Harness Options

Speaker 1: Today we're going to be taking a look at the best custom fit vehicle wiring on our 2012 Honda Accord. Over here we're going to have the CURT, part number C55502. Here in the center we're going to have the Tekonsha, part number 118420. Over here we're going to have the Hopkins, part number HM11143165.The Tekonsha and the Hopkins will work with the 2008 to 2012 Accord Coupe and Accord Sedan, whereas your CURT will work with the 2008 to 2012 Sedan, but only the 2008 Coupe. Let's go over some of the differences. Your Tekonsha and your Hopkins here, they're going to plug into the driver side and passenger side taillights, whereas your CURT is only going to plug into your driver side. more


Watch Video

5/14/2018 11:42:33 AM



Trailer Wiring Harness Installation - 2012 Honda Accord- Video

Trailer Wiring Harness Installation - 2012 Honda Accord

Today on our 2012 Honda Accord well be installing the Tow Ready T1 Vehicle Wiring Harness with Four-Pole Flat Trailer Connector, part number 118420. To begin with well need to go ahead and raise the trunk hatch on the vehicle. Well then need to go ahead and remove a few things out of the rear of the trunk. In this case we had a plastic cover that covered the whole trunk area. Well also need to go ahead and lift up the spare tire cover and its helpful if you go ahead and set the foam area that holds the jack as well as some other tools to change a spare tire out of the way. Next were going to go ahead and remove the center threshold section of plastic here by using a trim panel removal tool or large flathead screwdriver being careful not to break any clips on the underside. There are a total of four clips underneath, two on either side of the center trunk latch. Now that weve got our center threshold out of the way next were going to need to remove a total of three fasteners from either side of the vehicle to pull the interior back out the trunk. You use a flathead screwdriver and unscrew two of them and then you can remove the push fastener that way. The one on the bottom of the trunk youll actually need a large flathead screwdriver or a trim panel removal tool to get this one out. With these three removed you can peel back the interior of the trunk just enough to get your hand in there and make our connection as well as mount our converter box and make our ground connection. more


Watch Video

9/26/2013 11:11:40 AM



Trailer Wiring Harness Installation - 2012 Honda Accord 118500- Video

Trailer Wiring Harness Installation - 2012 Honda Accord 118500

Today on this 2012 Honda Accord Cross Tour we're going to install part number 118500 from Tow-Ready. Our first step is to go ahead and remove all floor coverings and the center storage bin. Now to remove the drivers side cargo tray there's a small cover we have to lift up and the bolts underneath it. We'll go ahead and remove the bolt and then remove the cargo tray. After we remove the tray if you look towards the bumper underneath the carpet you should see a connector wrapped up in blue tape. We'll go ahead and release the blue tape and then pull the connector out. more


Watch Video

12/28/2012 10:22:20 AM



  1