Trailer Wiring Harness Installation - 2008 Ford Fusion- Video
Today on our 2008 Ford Fusion, we're going to install the Towready T1 Vehicle Wiring Harness with Four Pull Flat Trailer Connector, part number 118422. To start our install we'll go ahead and open up our trunk. First we're going to go ahead, raise up the trunk liner here and just tuck it up here out of the way so we can get access to the side panels here and where our wiring is. So let's take this, you fold it up a little bit, it'll tuck it up out of the way. Now we need to go ahead and remove our threshold, there's a few push fasteners here, there's one here, there's two here on the lower part, and one over here on the side, so we'll go ahead and take those out with a trim panel remover tool or if you have a large flat blade screwdriver you can get underneath it and pop that out, so we're going to remove those and then we can move our threshold out of place. You just got to work them out, sometimes they pop out, sometimes they put up a little bit of a fight but they will come out if you just work back and forth. Just go ahead and set those aside, and before you can get your threshold free there are two more push fasteners here, right here, and on the other side, they do kind of blend in, you'll be able to see them, trim panel tool there and pop it free. And then we take our trim panel tool here, get it underneath the edge of our threshold and pop it free, and once you get all of this free, as you can see there's just these tabs here that clip in to the body, once you get it popped free you can just take your threshold and set it out of the way. more
5/22/2015 10:37:10 AM
