Trailer Wiring Harness Installation - 2008 Ford Focus- Video
Today on our 2008 Ford Focus, well be installing the Tow Ready Custom Fit vehicle wiring harness, part number 118457.Now to begin our installation, we'll open the trunk. With the trunk open, we'll need to temporarily disconnect the drivers side tail lamp. To do this, we'll undo the two plastic screws here on the drivers side holding in the plastic trim just behind the taillight.Then using some gentle force, we'll pry the trim away where we can move it off to the side. We'll then take a 10 mm socket and remove the two nuts off the taillight studs here.With that done, we'll use a pry tool to pry back on our taillight and remove it from the vehicle. Now this exposes our connector here that we'll T into. Now with our drivers side taillight out, we'll go ahead and repeat the same procedure and remove the passenger side taillight.Now that we have both taillights out, we'll take our new wiring harness and we'll route our four pole and the connector with the green wire to it down underneath the vehicle through the hole here between the body and the bumper cover. more
3/15/2013 3:00:24 PM
