T-One Vehicle Wiring Harness Installation - 2013 Ford Explorer- Video
Speaker 1: Today on this 2013 Ford Explorer, we're gonna review and install the T-one vehicle wiring harness with a seven way trailer connector, part number 118272.Let's go ahead and cover the parts that come with the kit. First off you have your T connector right here, which plugs into the factory wire harness on your Explorer. A generous lead of wire to go out to your seven pole connector. The port goes into your seven pole connector, it has this socket that the wires get pushed into and make a connection. Also, there's this locking piece that locks all our wires into place once their inside this connector. You have some zip ties to help hold the wiring in place. more
9/26/2018 9:32:25 AM
Best 2013 Ford Explorer Trailer Wiring Options- Video
Today we're going to be taking a look at the best wiring options for your 2013 Ford Explorer. Here we're going to have the CURT. That's going to be part number C56172. Over here we're going to have the Tekonsha. That's going to be part number 118540. Here's what our wiring's going to look like when it's installed. more
5/10/2017 9:57:39 AM
Trailer Wiring Harness Installation - 2013 Ford Explorer- Video
Today on our 2013 Ford Explorer we'll be installing the Tow Ready T-One Vehicle Wiring Harness with 4-pole flat trailer connector, part number 118540. Now to begin our install, we'll be underneath the vehicle on the passenger side. If you look to the outside of the muffler, you'll see two vehicle wiring connectors on this application. We'll be using the black connector. We'll first separate these two connection points by pressing on the locking tab and removing the socket from the connector. Then we can take the tow ready T-one connector and plug in line with the manufacturer's wiring. Taking the socket and plugging it into the connector and then the other end back into the vehicle wiring harness. Now with our connection made, we'll go ahead and take the 4-pole wiring and route it over to the center of the vehicle and down to the hitch staying away from the exhaust as much as possible. Once we finish routing, we'll go ahead and take the black zip ties provided with our install kit and secure the wiring. Once we have it secured, we'll go ahead and cut off the excess from the zip ties to clean up our install look. more
9/29/2014 2:39:56 PM
Trailer Wiring Harness Installation - 2013 Ford Explorer c56093- Video
All right, today in this 2013 Ford Explorer, were going to install part number C56093 from Curt. First thing we need to do is open up the back hatch and get access to our wiring. To do that, were going to have to remove the threshold in the back. Well start off by prying the threshold up closest to the door to loosen up the fasteners there. We use a trim pan tool to help get everything loosened up and started then we can go ahead and remove it from the car. Then, therell be two fasteners, one on each side of the threshold that we have to work loose as well. There's a small cover, right where our seatbelt goes in towards the floor, but go ahead and remove it, but pop out the bottom edge first, and push down the edge closest to the side. more
11/8/2013 3:22:34 AM
