bing tracking image

2011 Dodge Ram Pickup Custom Fit Vehicle Wiring Installation And Review Videos

     

Hopkins Endurance Fifth Wheel Wiring Harness Installation - 2011 Dodge Ram Pickup- Video

Hopkins Endurance Fifth Wheel Wiring Harness Installation - 2011 Dodge Ram Pickup

All right, today on this 2011 Dodge Ram pickup, 3500 series crew cab, we're going to install part number 41157. This is a Hopkins Endurancefifth wheel wiring harness, with a seven pole connector. OK, to start off our install, we need to find a location for our socket that we're going to install in the bed. Once we have that planned out, we'll go ahead and drill a quarter inch pilot hole Then we'll go back at it with a two inch hole saw OK, once we have our hole made, we'll go ahead and take our wire harness and run it through the hole. Well take the one end with the two connectors and go ahead and push it through the hole, and then let it fall out the bottom, then push the rest of our slack in place. OK, and then we'll save the other end to install into our seven pole connector We'll put some of the supply unintelligible 00:00:49 grease onto the terminals on the inside edge, then snap the two halves together. OK, once we have them together, we can go ahead and put the seven pole connector into the hole. And then we'll go ahead and use the provided hardware to attach it to the bed. Now the hardware is four self-tapping screws and washers. We'll position our seven pole connector, and then install our screws one at a time. We leave them loose until we have them all installed, and then we'll go ahead and tighten them down for good. All right, now go underneath the bed of the truck, and we'll go ahead and route our wire harness towards the bumper and towards the back side of the bumper where pre-existing seven pole connector is. Now we need to go ahead and disconnect the seven pole from the wire harness. We'll push down there's a small tab that we need topush down, and then we can go ahead and separate the connector from the wires. We'll let that go for now, and then we'll go ahead and take our new Hopkins wire harness and we'll get it ready to plug in the two halves. We'll go ahead and add the remainder of the unintelligible00:01:41grease on the terminals, and then just plug the two matching ends together. Again , we want to make sure everything remains snapped, so we know we're secure. OK, then we'll go ahead and take our extra length of wire and go ahead and route them up and out of the way, and secure them with some zip ties. One last thing is the white wire from the ring terminal.We need to ground that to the frame, so we'll go ahead and use a self-tapping screw to do that. In this case, we'll be using a number fourteen self-tapping screw. And with that, that will finish up our install of the Hopkins Endurance fifth wheel ninety degree wiring harness, with the seven pole plug, on our 2011 Dodge Ram pickup, 3500 series truck. . more


Watch Video

11/13/2013 1:53:52 PM



Trailer Wiring Harness Installation - 2011 Dodge Ram- Video

Trailer Wiring Harness Installation - 2011 Dodge Ram

Today on our 2011 Dodge Ram well be installing the Pollak fifth wheel and goose neck connector wiring harness part #: PK11932. First well need to locate a suitable spot for installing the connector in the truck bed. Then Ill take a pilot bit and run it through the bed and double check my location. Were going to go ahead and take a quarter inch bit which will be the same size as my pilot bit for my hole saw and drill out the hole. Now with my hole drilled out well go ahead and take the hole saw and make it large enough for the connector to fit through. With the large hole drilled out we can now take the wiring harness and feed it from underneath through the hole. more


Watch Video

5/31/2012 1:33:17 PM



  1