bing tracking image

2005 Dodge Ram Pickup Custom Fit Vehicle Wiring Installation And Review Videos

     

EZ Connector Magnetic 7-Way Trailer Connectors Installation - 2005 Dodge Ram Pickup- Video

EZ Connector Magnetic 7-Way Trailer Connectors Installation - 2005 Dodge Ram Pickup

Speaker 1: Today on our 2005 Dodge RAM 3500, we're going to be doing an installation of the EZ connector magnetic T connector with seven way trailer connector. Part number 319-R7-06D.Upgrade your RAM to work with the magnetic EZ connector seven ways. This is going to allow you to have a standard seven way connection on a trailer that has a magnetic EZ connector. It's a face to face connection. There are no pins, or blades to break or bend. The magnetic connection is strong enough to hold it in place, but it's easy to disconnect when needed.It's going to allow you to maintain the factory seven way connection on your RAM, so you can still tow trailers with standard seven way connectors. more


Watch Video

3/19/2018 4:42:09 PM



Fifth Wheel and Gooseneck Wiring Harness Installation - 2005 Dodge Ram- Video

Fifth Wheel and Gooseneck Wiring Harness Installation - 2005 Dodge Ram

Today on our 2005 Dodge Ram Pickup, well be installing the Bargman 5th Wheel Gooseneck 90 Degree Wiring Harness with 7-Pole plug, part number 51-97-411. To begin our install, well first locate in the pickup bed where well be mounting our 7-pole, then using a smaller bit for our pilot hole, once weve located a spot well go ahead and drill our hole. Well go ahead and drill out using the two inch hole saw as recommended per the instructions. Now with the large hole drilled out, well go ahead and feed half of our T-connector through the hole then our other plug followed by the remainder of the wire until our 7-pole mounts flush with the bed. Then using the self-tapping screws provided with our install kit, we can go ahead and secure the 7-pole plug to the bed side. Next well get underneath the vehicle and start routing our wire over to the back of the bumper where the manufacturers wiring meets the bumper. Here at the back of the bumper, well go ahead and disconnect the manufacturers wiring from the back of the 7-pole plug at the bumper. more


Watch Video

4/3/2013 2:54:45 PM



  1