bing tracking image

2010 Dodge Nitro Custom Fit Vehicle Wiring Installation And Review Videos

     

Trailer Wiring Harness Installation - 2010 Dodge Nitro- Video

Trailer Wiring Harness Installation - 2010 Dodge Nitro

Today on our 2010 Dodge Nitro, well be installing the Curt T-Connector 4-Pole Wiring Harness, part #C56183. To begin our install, well first open up the rear hatch and then well remove the two push pin fasteners that secure the rear taillight assembly. To remove the fasteners, we use a flat blade screwdriver prying out on the center and then completely removing the fastener. With both fasteners removed, well set them aside and then remove the taillight assembly, being careful not to break the alignment tabs underneath. After we pull the taillight assembly out, we can press on the locking tab for the connector and remove it from the assembly, setting the taillight assembly aside. Well go ahead and move over to the passenger side and repeat the same process. more


Watch Video

10/23/2013 9:37:57 AM



Trailer Wiring Harness Installation - 2010 Dodge Nitro 118554- Video

Trailer Wiring Harness Installation - 2010 Dodge Nitro 118554

Today on our 2010 Dodge Nitro, well be installing the Tow Ready T-One vehicle wiring harness, part number 118554.Now to begin with, well need to raise the rear hatch of the vehicle. Well need to remove the light assembly from both the passenger and the drivers side. Well begin here on the drivers side. A flat head screwdriver or a trim panel removal tool works great for getting these two push pins that hold the light assembly in place. Once we have each of the push pin fasteners removed, well go ahead and work the light assembly out of the body of the vehicle.There are two additional tabs that just snap into place on the outer part of the light assembly. Once you have the light assembly worked out of the body, well go ahead and unplug the factory wiring harness from the back of it. more


Watch Video

10/21/2013 6:47:11 AM



Wiring Harness Installation- 2010 Dodge Nitro- Video

Wiring Harness Installation- 2010 Dodge Nitro

Today on this 2010 Dodge Nitro we are going to install part number 118455 from Tow Ready. This is our T-One wiring harness. This T-One wiring harness does mount behind the tail lights on both sides of the vehicle. Also, there is a lead that will be run up to the battery for our 12 volt power supply. We will open the hatch and remove the tail lights. The lights are held on by the plastic rivets here and here. We are going to use a screw driver and pry the rivets out a little bit. Then we will use a trim tool and pull out the rivet. Pull straight back on it to release it. Then disconnect the light from the harness by pushing down on this tab right here. Go ahead and repeat for the other side. :45 more


Watch Video

3/30/2011 1:19:58 PM



  1