bing tracking image

2008 Dodge Grand Caravan Custom Fit Vehicle Wiring Installation And Review Videos

     

Best 2008 Dodge Grand Caravan Trailer Wiring Options- Video

Best 2008 Dodge Grand Caravan Trailer Wiring Options

Today on this 2008 Dodge Grand Caravan, we're going to show you the best wiring options that are available. This is pretty easy. We have two options here, we have one from Tekonsha and one from CURT. Let's go ahead and cover the differences between the two pieces we've got here. First off, let's look into the Tekonsha. The turn signal circuits, both green and yellow wires, are going to be rated for 4.2 amps per circuit, which means you can have two light bulbs on each side of the trailer, most of time you're going to have one, but there's extra capacity there. more


Watch Video

8/15/2019 3:17:14 PM



Trailer Wiring Harness Installation - 2008 Dodge Grand Caravan- Video

Trailer Wiring Harness Installation - 2008 Dodge Grand Caravan

Today on our 2008 Dodge Grand Caravan well be installing the Curt T Connector Wiring Kit part number C56019. Our first step will be to open the rear cargo door then well remove the drivers side tail light housing by removing the two fasteners and gently prying it away from the vehicle. As you pry the housing away from the vehicle be careful not to break the alignment tabs that youll be able to see once we have the taillight assembly removed from the vehicle. Next, well go ahead and remove the black connector from the rear taillight socket. First well unlock the red locking tab then press on the connector lock and remove it from the taillight socket. Next, we can take our yellow and brown wire from our new T connector and plug it in line with the manufacturers wiring. more


Watch Video

8/7/2012 10:11:46 AM



Trailer Wiring Harness Installation - 2008 Dodge Caravan- Video

Trailer Wiring Harness Installation - 2008 Dodge Caravan

Today we are going to install part number 118552 from Tow Ready on our 2008 Dodge Grand Caravan. First what we need to do to start is get behind the tail lights. So we will have to open up the trunk and take out 2 screws on each side to undo the tail lights. There are 2 torque screws that have to come out and you just simply pry off the light. You will see 2 tabs, just pull straight out from there. For now we will just go ahead and let the light sit there so we will have to make our T1 connector right here. Again it is the same thing for the other side. To begin our install, we will take our 4 pole and our converter box and stick it behind the bumper. And it will come out below the bumper. Also the wires going to the passenger side will go down there too. These will eventually get run down underneath the bumper to the other side. Just to make sure we have the socket to hook up take a look at the outside. Obviously this is going to be your reverse light. And your turning signal and running lights and brake lights are going to be this bulb. So you are going to want to take this socket and this bulb apart. You have to unlock it and it should come apart just like so. Then you reinstall the T-1 connector in the same spot. Then take the other 2 halves you have left over and connect those together. Make sure you put the red locks back into place. more


Watch Video

8/7/2008 12:50:47 PM



  1