bing tracking image

2008 Dodge Durango Custom Fit Vehicle Wiring Installation And Review Videos

     

Trailer Wiring Harness Installation - 2008 Dodge Durango- Video

Trailer Wiring Harness Installation - 2008 Dodge Durango

Today in our 2008 Dodge Durango we'll be installing the Curt T-Connector Vehicle Wiring Harness with 4-pole Flat Trailer Connector, part number C55597. To begin our install we'll first go ahead and open up the rear hatch and locate the 2 fasteners that secure the driver's side taillight assembly. To remove them they'll need to be pried in the center and then you can remove the entire fastener. We'll go ahead and use an interior trim panel tool but also a flat blade screwdriver would work. Now with the centers pried out we'll remove the fasteners and then the taillight assembly. Be careful not to break the alignment tabs underneath as you remove the taillight assembly. Next we'll go ahead and disconnect the manufacturer's wiring from the back of the taillight socket. more


Watch Video

6/30/2014 1:01:20 PM



Trailer Wiring Harness Installation - 2008 Dodge Durango 118390- Video

Trailer Wiring Harness Installation - 2008 Dodge Durango 118390

Today on our 2008 Dodge Durango we'll be installing the Tow Ready T1 Vehicle Wiring Harness with 4-pole flat trailer connector part number 118390. Now to begin our installation we'll go ahead and open the rear cargo door and remove the taillights. Here on the passenger side we'll remove these two push pins and then simply pull straight back on the taillight assembly. We can then unplug it by pushing the red push pin off to the side and then removing the connector from the taillight. Now that we have our passenger side taillight assembly out, we'll go ahead and repeat the same procedure and remove the drivers side taillight assembly. Now here on the drivers side we can plug in our T1 harness that contains the yellow wire. more


Watch Video

6/11/2013 8:11:39 AM



  1