Hopkins Endurance Fifth Wheel Wiring Harness Installation - 2014 Chevrolet Silverado 2500- Video
Today on our 2014 Chevrolet Silverado 2500 we're going to be taking a look at and also showing you how to install the Hopkins Endurance 5th Wheel Gooseneck 90 Degree Wiring Harness with the 7 Pole Plug. Part number is 41157. This is going to be the important part of our wiring harness; this is going to give us our 7 pole plug. Our 7 pole plug takes care of all the lighting for our trailers. It can also send the reverse signal, it can send 12 volt power back, and also our brake controller signal back to our trailer so we have all of our functions working properly. This is designed to plug directly in to the factory wiring harness that's already at the back of our truck. more
12/20/2016 10:15:40 AM
Trailer Wiring Harness Installation - 2014 Chevrolet Silverado 2500- Video
Today in this 2014 Chevrolet Silverado 2500, we're going to show you a 5th Wheel and Gooseneck 90-degree Wiring Harness with a 7-Pole Plug, part #50-97-410 from Bargman. With this part number this is what you get. You get your 7-pole plug, and take an extra point that goes into your wiring harness behind your bumper, get a little spacer block which will go behind your 7-pole connector if you need it, in case this backside of the connector hits the outside edge of the truck or outside skin. Then you have some self tapping screws that come with the kit to help attach it. If you take a look at the lid here, it also has a legend to tell you what pin does what if you have to do some wiring diagnostics. Pretty simple to install. The hardest point really is just trying to find a place to locate it. more
6/17/2015 9:47:29 AM
Fifth Wheel and Gooseneck Wiring Harness Installation - 2014 Chevrolet Silverado 2500- Video
Today on our 2014 Chevrolet Silverado 2500 we'll be installing the Draw-Tite 5th Wheel and Gooseneck Wiring Harness with 7-pole Trailer Connector, part number 20110. To begin our install we're going to start in the pickup bed. We're going to find a suitable mounting location for our 7-blade connector. Here in the side of the pickup bed on the driver's side behind the wheel well but in front of the tail light where the bed-liner is flush or flat against the sheet metal is a good location. Once we find that we'll go ahead and drill out a pilot hole. I'm going to use a 1/4" bit because it will also match the pilot bit of the hole saw that we're going to have to use to drill out our hole. Once I have my pilot hole made we'll go ahead and bring in the 2" hole saw. Now with our hole drilled out, we're going to move underneath the pickup. more
1/26/2015 10:34:10 AM
