2010 Chevrolet Malibu Custom Fit Vehicle Wiring Installation And Review Videos

Trailer Wiring Harness Installation - 2010 Chevrolet Malibu- Video

Speaker 1: Today on our 2010 Chevrolet Malibu, we're going to be installing the Curt T-connector Vehicle Wiring Harness, part number C56027. This connector is going to give you all of the lighting you need for your trailer through a 4-pole flat connector. It provides you with your left turn signal, right turn signal, taillight, and brake lamps, all the necessary required lights. It has an included dust cap on the end to keep out any dirt and debris and prevent corrosion, and also works kind of nice with your safety chain loops to hold it in place. There's no splicing required. It just plugs right into your existing tail lamp assemblies. more

8/2/2018 1:47:12 PM

Best 2010 Chevrolet Malibu Trailer Wiring Options- Video

Speaker 1: Today we're going to be taking a look at the best vehicle wiring options for a 2010 Chevy Malibu. Now these are going to be our three wiring options for your Malibu. Over here on your left side, you're going to have Tekonsha, part number 118450. Here in the center, we're going to have the Curt, part number 56027 and over here on your right, you're going to have the Hopkins, part number 46255.All these are going to provide the proper lighting for your trailer with the four pole connection. If you have the LTZ model, these two will not work, however the Hopkins will work with the LTZ model, along with any of the other models.Your Tekonsha and your Curt here are going to be very easy to install. They're going to plug into your existing wiring behind your tail lights. more

1/8/2018 11:54:46 AM

Trailer Wiring Harness Installation - 2010 Chevrolet Malibu 118450- Video

Today on this 2010 Chevy Malibu, well be installing the Tow Ready T1 vehicle wiring harness, part number 118450.To start, well need to open up the rear cargo or trunk. Then well go ahead and take the spare tire cover and push it forward, clearing the lip of the rear threshold.Next well pull up on the rear threshold, unlocking it from its mounting position. Next well need to remove the fastener securing the carpeting behind the drivers side taillight assembly. There are two cargo hooks, theyll need to be unscrewed and two pushpin fasteners that will have to pop out here on the drivers side.Then well go ahead and fold the carpeting out of the way exposing the three plastic wing nuts that secure the taillight assembly in place. Well remove these three wing nuts. Now well go ahead and remove the taillight assembly, simply popping it out of position. more

3/15/2013 3:00:36 PM