bing tracking image

2007 Chevrolet Express Van Custom Fit Vehicle Wiring Installation And Review Videos

     

Best 2007 Chevrolet Express Van Trailer Wiring Options- Video

Best 2007 Chevrolet Express Van Trailer Wiring Options

Today on our 2007 Chevrolet Express we'll be looking at our best trailer wiring options. We have two wiring options here today for the Chevrolet Express Van. Now both of these options are for vehicles that don't have the factory tow package installed. Off to the right we have the CURT T-Connector, part number 55540. Over here to the left we have the Hopkins Plug-N-Tow, part number 31345. Now both of our wiring harnesses will attach in the same manner. They both will go into the factory taillight connectors in-line, no cutting, no splicing required. more


Watch Video

12/20/2016 8:27:04 AM



Trailer Wiring Harness Installation - 2007 Chevrolet Express Van- Video

Trailer Wiring Harness Installation - 2007 Chevrolet Express Van

Today on our 2007 Chevrolet Express Van, we're going to be installing the Tow-Ready T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector, part number 118392. We're going to need to begin by opening up the rear doors of the van. We're then going to need to gain access underneath this trim panel here because our wiring is plugged in behind it. Now, in order to remove our panels, we'll be using a trim panel removal tool or you can use a large flat-head screwdriver. Go ahead and set that panel aside, then need to remove this lower panel. Now, we're going to begin over here on the driver's side. We'll be disconnecting this plug right here and adding out T-Connection in line. more


Watch Video

12/9/2014 2:19:48 PM



Trailer Wiring Harness Installation - 2007 Chevrolet Express Van 31345- Video

Trailer Wiring Harness Installation - 2007 Chevrolet Express Van 31345

Today on this 2007 Chevrolet Express Van we are going to install Hopkins wiring harness part number 31345. We are going to start the installation off inside the rear cargo area of the Express Van and the ports that we are going to be plugging the wiring harness into are located inside the van basically behind where the tail lights are on both the driver and passenger sides. Starting off over on the driver side with this large connecting port right here we are going to disconnect these two pieces and plug the harness in line and that will be the connection on the driver side. If you look on the top you can see there is a clip holding these two pieces together, push that tab in, pull away the bottom section. 00:45 more


Watch Video

2/25/2011 7:56:54 AM



  1