bing tracking image

2008 Chevrolet Equinox Custom Fit Vehicle Wiring Installation And Review Videos

     

Trailer Wiring Harness Installation - 2008 Chevrolet Equinox- Video

Trailer Wiring Harness Installation - 2008 Chevrolet Equinox

Today on our 2008 Chevrolet Equinox, we'll be installing the T-One Vehicle Wiring Harness for a 4-Pole Flat Trailer Connector, part number 118432. Now when we want to hook up to our trailer, all we have to do is open our jack door here, grab our wiring harness, set it to the side of our hatch latch right here so it doesn't get closed on it, and close our hatch down. Our wiring is in a readily accessible spot right now to hook up to our trailer. We'll take our dust cover off, plug in our trailer wiring and we're good to go. Now when we get to our destination and we've unhooked our trailer, all we have to do is replace our dust cover here, open our hatch back up, tuck our wiring inside the jack compartment, put our jack cover door back in place and it's like our wiring is not even there. It's tucked up out of the way. We don't have to worry about any of our cargo damaging the connector or snagging up on the wires and ripping the wiring out. more


Watch Video

10/19/2016 12:09:42 PM



Best 2008 Chevrolet Equinox Trailer Wiring Options- Video

Best 2008 Chevrolet Equinox Trailer Wiring Options

Today we'll be taking a look at the best wiring options for your 2008 Chevrolet Equinox. Up top here we've got the Tekonsha T-1, part number 118432. Then here on bottom we've got the Curt, part number C56012. The biggest difference between these two harnesses is on the T-1, it's got this eyelet that's separate for the ground wire where on the Curt the ground wire's built in to the connector so that it ground to the vehicles factory electrical system. Another difference is that here on the T-1 connector the dust cover is molded into the four pole plug and on the Curt the dust cover is separate so you'll slide it over in order to cover your plug. With both of these wiring kits, they're going to install the exact same way. They're going to have three fuses and two relays that are going to need to be installed in the under-hood fuse box. more


Watch Video

10/7/2016 3:31:20 PM



Trailer Wiring Harness Installation - 2008 Chevrolet Equinox C56012- Video

Trailer Wiring Harness Installation - 2008 Chevrolet Equinox C56012

Rate your transcript OrderClientKevin BrossRef #20676Order #TC0843084131 Today is 2008 Chevrolet Equinox we're going to install part number C56012 from Curt. Okay, to start off we'll go ahead and open the back hatch of the vehicle. Then we need to go to the jack storage compartment. We'll temporarily remove the jack so we can find the port underneath of it. We'll locate the port and then take the wire harness and plug it directly into it. That's all we have to do at the back. Go ahead and re-install the jack and leave the cable out for later. more


Watch Video

8/19/2014 2:48:03 PM



  1