Trailer Wiring Harness Installation - 2013 Jeep Wrangler- Video
Today on our 2013 Jeep Wrangler we will be installing the Dutton-Lainson electrical quick connect part number DO24085. I will be installing this so that we can power a hitch accessory such as a wheelchair lift. To being our install well first need to go ahead strip back our grey duplex cable. Well remove some of the grey sheathing and approximately a half inch of the insulation around the wire. Now with that done were going to go ahead and solder the ends of our new quick connect directly to the wire using a heat gun and solder we will go ahead and do this now. Now we have both ends solder we will go ahead and let them cool down. more
9/27/2013 8:33:03 AM
Convert-A-Ball Cushioned Weight Distribution Shank Review - 2013 Jeep Wrangler- Video
Today on our 2013 Jeep Wrangler we'll be test fitting a convert-a-ball cushioned weight distribution shank for two inch hitches rated at 10,000 pounds. Part number AMAC1. We'll begin our test fit by sliding our shank into the opening of the hitch and securing it with the pin and clip. In the dropped position you can see this weight distribution shank can be used with the pintle hook combo with balls. Part number Ph4. A ball mount adapter, part number BA-1 or a clevis pin adapter part number CA-1. more
9/25/2013 1:50:08 PM
Convert-A-Ball Ball Mount Adapter Review - 2013 Jeep Wrangler- Video
Today on our 2013 Jeep Wrangler, well be test fitting the Convert-A-Ball Ball Mount Adapter for Convert-A-Ball Weight Distribution Shank part number BA-1. Again, well be using this with a Convert-A-Ball Weight Distribution Shank part number AMAC1.With the Weight Distribution Shank already assembled on to our vehicle in the drop position, well secure the Ball Mount platform in this lowest position with the pins and clips. With the Ball Mount platform in its lowest position, we can measure from the ground to the top of the platform, getting a measurement of about 12 and one quarter of an inch.We can out flip the Ball Mount platform over into the rise and secure it at the very top of the Weight Distribution Shank. We can then measure from the ground to the top of the ball platform getting a measurement of about 20 and one quarter of an inch. Now, if your vehicles hitch height matches our and your trailers ride height is on or in between these two measurements, this would be an appropriate Ball Mount for you.That will complete todays test fit for the Convert-A-Ball Ball Mount Adapter for a Convert-A-Ball Cushioned Weight Distribution Shank part number BA-1 on our 2013 Jeep Wrangler. . more
9/25/2013 1:48:36 PM
Trailer Brake Controller Installation - 2013 Jeep Wrangler Unlimited- Video
Today on our 2013 Jeep Wrangler Unlimited well be installing the Prodigy P2 brake controller, part number 90885 along with the seven pole install kit ETBC7. Well first take our seven pole mounting bracket and install it onto the new seven and four pole connector. Using the hardware provided with our install kit we can secure it. Next well take the seven pole bracket and attach it to the Tow Ready Universal mounting bracket, part number 18140. Well go ahead and attach the universal mounting bracket to the hitch with the clamp provided. Now, before we install the seven pole connector and bracket onto the hitch well go ahead and remove the manufacturers four pole to make room for the seven pole bracket. more
11/20/2012 9:18:11 AM
