Yakima Ski and Snowboard Racks Review - 2020 Mazda CX-5- Video
AJ: What's up everybody It's AIJ with etrailer.com. Today, we're going to be checking out the Yakima FreshTrack on our 2020 Mazda CX-5. It's going to be a great way to get your skis and snowboards out of your vehicle and up on the roof, giving you more leg room when you go on your adventures. Plus, if you're coming back from your adventures, you don't have to throw them in your car and get it all wet or nasty from any of the salt that's on that stuff. You can keep them up on your roof, up and out of the way. Let's check it out.I'm going to hop up there to get a closer look. more
11/13/2020 5:27:30 PM
Thule Ski and Snowboard Racks Review - 2020 Mazda CX-5 TH32WV- Video
AJ: What's up everybody, it's AJ with etrailer.com. Today we're going to be checking out the inaudible 00:00:04 snow sport on our 2020 Mazda CX-5. It's going to be a great way to haul our skis and snowboards on the roof of our vehicle, which means they don't have to be inside the vehicle. It gives you more leg room on those trips, makes everybody happier overall, you don't get that mess if you're coming back from your trip, you don't get that mess on the inside of your vehicle; it's up on top of it. Let's hop up there and check it out.It attaches to our arrow bars with these clamps that just go around, and you can tighten them down right here and here; it's nice and tight. I can shake the whole car back and forth with it. more
11/13/2020 5:27:26 PM
Rhino Rack Ski and Snowboard Racks Review - 2020 Mazda CX-5- Video
AJ: What's up, everybody, it's AJ with etrailer.com. Today, we're going to be checking out this Rhino Rack snowboard and ski carrier on our 2020 Mazda CX-5.Now, this is going to be a great way to get your snowboard and your skis up out of your vehicle, making more leg room for your passengers on your adventure, getting them up on your roof and out of the way. Plus, if you're coming back from your adventure and they're all snowy, you don't bring that mess inside the vehicle, either, so that's two good things about it. Let's check it out.You're going to hop up here. It's made out of a nice aluminum, so it's going to hold up; you don't have to worry about the elements causing issue, or any salt that might be in the snow areas. It's not going to corrode it or cause any issues; it's going to hold up just fine. more
11/13/2020 5:27:21 PM
Yakima FatCat Ski and Snowboard Carrier Review - 2013 Mazda 5- Video
Today on our 2013 Mazda5, we're going to be test fitting the Yakima Fatcat 6, a locking rooftop ski and snowboard carrier with a six-ski or four-board capacity, Part Number Y03088. With our Yakima control towers roof rack system already installed on the Mazda, we'll begin our test fit by grabbing the front half of our carrier and placing it onto our front load bar. We'll bring both of our black rubber-coated metal straps around the underside of our load bar and fit the one closest to us into the foot of the carrier. We'll then open our top jaw, reach in and lift up on the black lever and loosen it slightly. This allows the small gray catch to lift up, allowing us to cam our buckle closed. We can then tighten that black lever down slightly and push it down to secure that gray catch around our buckle. With the passenger side secure, we'll now make our way around to the driver's side. We just repeat that same process. With the front half of our carrier secure, we'll now grab the rear half and place it onto our rear load bar. We'll want to take a quick look to be sure we have both halves of the carrier centered, then we can repeat the same tightening process that we used for the front. With both halves of our carrier secure, we'll now press the black buttons located here on the end. more
5/27/2014 11:03:06 AM
Whispbar Roof Ski and Snowboard Carrier Review - 2013 Mazda 5- Video
Today, on our 2013 Mazda5, we're going to be test fitting the Whispbar Locking Rooftop Ski and Snowboard Carrier with a 6-ski or 4-board capacity in silver. It's part number WB-300. With our Yakima Control Tower Roof Rack System already installed on the Mazda, we'll begin our test fit by grabbing the front half of our carrier and placing it onto our front load bar. We'll press the black button located on the end of the carrier. This will allow us to open our top jaw. Lift up on the black lever and loosen it slightly. This disengages the catch for our buckle. more
5/21/2014 12:33:07 PM
Filter Videos
Filter Videos
