bing tracking image

2011 Subaru Forester Custom Fit Vehicle Wiring Installation And Review Videos

     

Best 2011 Subaru Forester Trailer Wiring Options- Video

Best 2011 Subaru Forester Trailer Wiring Options

Ryan: Hey everybody, Ryan here at etrailer. Today, we're going to be taking a look at our best trailer wiring options for your 2011 Subaru Forester.So today we're going to be talking about three different wiring kits. They're all going to have a four way flat connector. And with that being said, this one over here is the Curt. The one here in the center is made by Tekonsha. And this one over here is made by Hopkins. more


Watch Video

2/5/2021 12:14:32 PM



Trailer Wiring Harness Installation - 2011 Subaru Forester- Video

Trailer Wiring Harness Installation - 2011 Subaru Forester

Today on our 2011 Subaru Forster, we'll be installing the Curt T Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector, part number C56040. Now to begin our install, we'll first go ahead and open up the rear hatch. Then we'll take the spare tire cover from the rear storage compartment and set it aside. Next we'll remove the center storage compartment, which will just lift up and remove. Remove the carpeting panel here on the drivers side, and then the storage compartment on the drivers side. The storage compartment on the drivers side has two push pin fasteners that will secure it in position. To remove them, we use a flat bladed screw driver or an interior trim panel tool to pop each fastener off. more


Watch Video

11/7/2014 12:58:37 PM



Trailer Wiring Harness Installation - 2011 Subaru Forester 118467- Video

Trailer Wiring Harness Installation - 2011 Subaru Forester 118467

Today working on a 2011 Subaru Forester, were going to install a Tow-Ready T-One Connector part# 118467. Go ahead and remove the cargo cover, were going to remove the center foam tray and the driver's side foam tray to access the wiring underneath. And you see it gives us access to the manufacturer's trailer wiring. Now we can take our new Tow-Ready Connector and plug it into the manufacturers connection port. With our port connected we need to mount our converter box, we'll peel back the cover of the two-side adhesive and mount it to the sheet metal. Were mounting it to the sheet metal make sure you've got a good flat clean surface. more


Watch Video

1/26/2012 4:03:00 PM



  1