Best 2013 Honda CR-V Custom Fit Vehicle Wiring Harness Options- Video
Hey, everyone. Ryan here at etrailer. Today, we're gonna be checking out our best trailer wiring options for your 2013 Honda CR-V. We're gonna have a few different options as far as the trailer wiring goes. So, right here we have a kit made by Tekonsha. Here in the middle, we have a kit made by CURT, and over here, we have a kit made by Hopkins. more
1/29/2024 1:35:23 PM
Hopkins Plug-In Simple Vehicle Wiring Harness Installation - 2013 Honda CR-V- Video
Speaker 1: Today on our 2013 Honda CRV, we're going to be installing the Hopkins Plug-In Simple Vehicle Wiring Harness with 4-Pole Flat Trailer Connector; part number HM11143274.This 4-pole flat connector is going to provide you with all the necessary trailer lighting circuits that you need. It's going to have your left turn, right turn, brake lights and tail lights. This 4-pole flat connector's going to live inside your vehicle. You can coil it up and keep it tidied nice inside of your spare tire compartment. When you're ready to use it, you just uncoil it, drape it over the back, you do want to make sure you avoid your striker, so it doesn't get damaged, and you can shut your tailgate, plug it in to your trailer, and you're ready to go.It's okay that it's pinched between your lift gate and your bumper here. It's got a rubber cushion on both edges, that helps keep out moisture, so that'll allow this wire to sit in there freely without being pinched or damaged.The circuits going to be fuse protected, both at your vehicles fusebox and also back at the control unit for your 4-pole flat connector. more
4/18/2018 12:05:41 PM
Trailer Wiring Harness Installation - 2013 Honda CR-V- Video
Today on our 2013 Honda CRV we'll be installing the Curt T-connector vehicle wiring harness with four pole trailer connector, part number C56158. To begin with we'll need to go ahead and open up the rear hatch of the vehicle. Next we'll go ahead and remove the cover that covers the spare tire. Go ahead and set this aside for now. You won't reinstall it until the very end. To install our four pole we'll need to remove some of the interior panels. To begin with we'll remove this tie-down loop here and move on to the pushpin fastener on the drivers side. more
7/9/2013 10:33:42 PM
Trailer Wiring Harness Installation - 2013 Honda CR-V 118561- Video
Today on our 2013 Honda CRV we'll be installing the Tow Ready T1 Vehicle Wiring Harness, part number 118561. To begin our install we'll first need to remove the spare tire cover. Then we're going to remove the threshold. To remove the threshold we'll first need to remove the two push pin fasteners. To remove these fasteners we'll need to use a small screwdriver, press in on the center portion of the fastener which will assist in releasing it then we can push it up from underneath and remove it.Once both fasteners are removed we can then gently pull up on the rear threshold and release the fasteners underneath. Now with the rear threshold set aside we'll need to remove the trim panel just behind the second row seating that comes off the driver's side quarter panel. more
6/26/2013 5:28:51 AM
