Hopkins Endurance Fifth Wheel Wiring Harness Installation - 2012 Ford F-250- Video
Today, on our 2012 Ford F 250, we'll be installing the Hopkins Endurance 5th Wheel Gooseneck 90 Degree Wiring Harness with 7 Pole Plug, Part Number 41157. To begin our install, we'll first locate in the pickup bed where we will be mounting our new 7 pole connector. Here on the driver side between the wheel well and the rear tail light, would be a perfect location. We'll go ahead and use a pilot bit to drill out the hole. We'll go ahead and use our hole saw to drill out the larger hole so that it will fit the socket and connector. Now, with the large hole drilled out, move underneath the vehicle. We'll need to remove the manufacturer's 7 pole plug to gain access to the connector wiring. more
7/7/2014 10:40:38 AM
Trailer Wiring Harness Installation - 2012 Ford F-350- Video
Today on our 2012 Ford F350 we'll be installing the Bargman Fifth Wheel and Gooseneck ninety-degree wiring harness with 7-pole plug nine foot long, part number 50-97-410. To begin with we will locate a position in the bed that we will mount the wiring plug. In this case we went ahead and chose an area on the side of the bed on the drivers side just in front of the wheel well, and went ahead and made sure that there was pretty of clearance behind the inner bed wall. We went ahead and used a 3/4 inch bit and put a pilot hole. Next we'll go ahead and use a two-inch hole saw to drill our hole. Now we'll go ahead and feed the wires from the wiring harness through the hole pushing all the wiring through so that the plug will sit flush against the side of the bed. more
6/11/2013 3:15:01 AM
Fifth Wheel and Gooseneck Wiring Harness Installation - 2012 Ford F-350- Video
Today on our 2012 Ford F-350, well be installing the Pollak 5th Wheel Gooseneck T-Connector 7-Pole, part number PK11893-11932. Now to begin our installation, at the factory 7-pole, well need to unplug the connector. Well push the gray lock tab back and remove it from the factory 7-pole. Well take the T-connector from the Pollak Gooseneck Harness and plug one side into the connector and the other into the factory 7-pole. With those connections made, well route the wire up through the drivers side rear of the bed where well mount our bed 7-pole. We can then move up into the bed of the truck where well find a suitable location here on the drivers side rear of the bed, and after finding that suitable location, well use a center punch to start a hole. more
6/18/2012 11:08:12 AM
Fifth Wheel and Gooseneck Wiring Harness Installation - 2012 Ford F-250- Video
Today on our 2012 Ford F250 were going to install the Pollak 7 way connector in the pickup bed, part #: pk11893-11932. To start our install, we need to go ahead and cut the hole in the pickup bed. In this application were going to mount it just behind the driver side wheel well. The flat spot here to mount on our 7 way right in the side of the bed. Well go ahead and take our hole saw a bit and make our hole. Now well go ahead and take the 10 pole end of our wire and feed it up from underneath the pickup bed through our hole. more
3/12/2012 6:26:05 PM
