Hopkins Endurance Fifth Wheel Wiring Harness Installation - 2006 Chevrolet Silverado- Video
Today on our 2006 Chevy Silverado well be installing the Hopkins Endurance fifth wheel and gooseneck 7-pole wiring harness, part number 41157. First were going to locate where were going to install the 7-pole plug in our pickup bed. Here towards the end of the bed would be a perfect location. First well go ahead and drill a pilot hole. Then well go ahead and enlarge it as per the instructions with a hole saw bit. Now well move underneath the vehicle where well locate the manufacturers 7-pole plug and remove the manufacturers wiring. more
8/20/2013 4:13:29 AM
Trailer Wiring Harness Installation - 2006 Chevrolet Silverado- Video
Today on our 2006 Chevrolet Silverado, we will be installing the Bargman 5th Wheel/Gooseneck 90 degree Wiring Harness with 7-Pole plug, part number 50-97-410. To begin our install we will first locate where were going to mount the 7-Pole plug. Here on the driver side bed behind the wheel well is a great location. Now well go ahead and drill out a hole large enough to fit the 7-Pole connector. The size will be indicated in the instructions. Now with our hole cut, well go ahead and feed the wiring harness down into the cutout hole being careful not to cut the wire on the sharp edges along our cutout. Now with the wire fed underneath, well go ahead and center up the 7-Pole plug against the sheet metal of the side of the pickup bed and use the self-tapping screws to secure it. more
8/19/2013 3:34:01 PM
Trailer Connector Socket Installation - 2006 Chevrolet Silverado- Video
Today on this 2006 Silverado 1500 were going to install 40975 from Hoppy, and our bracket will simply bolt on to the bottom of the bumper at this location right here. So what we need to do is pull out the wiring harness from the vehicle that is stored above the spare tire, and its got plenty of lead, you just got to pull it out. We are going to leave this alone for now, and we are going to go ahead and mount our bracket to the bumper. It comes with two self tapping screws. Okay right now we will take our wiring harness, remove the cap and we will take our plug and just snap it into the bracket, and then make our connection behind it. And with that were already done. more
10/19/2011 12:11:37 PM
