Tow Bar Wiring Diode Installation - 2011 Jeep Liberty- Video
Today on this 2011 Jeep Liberty, we are going to install part number 48955. First off, what we are going to do for our wire harness is find a spot where we are going to locate the 4-pole end. And you can do it anywhere you want. We are going to actually run it to the center on this vehicle right here for now. Put it over this pin. And then we will go ahead and start routing our cable from the front of the vehicle all of the way back. Just stay away from anything moving, like the suspension components, or anything hot, like the exhaust. OK, we will take our ground wire with the ring terminal and we will run it straight to the frame. We will go ahead and show you how we routed our wire. Above the sub-frame there is a piece of tubing that goes all of the way across the suspension. So we actually thread it through from the front to the rear. It is actually easier to see from the back side right here. And then we were able to run it through the frame, using the wire pull. We were able to go all of the way out to the back of the vehicle. We were also able to route it through the back cross member. Our green and brown wires go over to the passenger side of our vehicle. And our yellow and brown wires will go over to the driver side. 1:02 more
9/15/2011 2:59:03 PM
