Trailer Wiring Harness Installation - 2006 Toyota Highlander 118413- Video
Today, on our 2006 Toyota Highlander, we'll be installing the Tow Ready T-OneVehicle Wiring Harness with 4 Pole Trailer Connector, part number 118413.First, before we install our Tow Ready harness, we'll need to access themanufacturers wiring. So, we'll start by opening up the rear cargo door and removingthe rear cargo mat. Then we'll remove the corner covers for the rear storagecompartments and lift up the center compartment. Now, we'll remove the two pushpinfasteners, securing the center section in place. Here we'll be using an interior trimpanel tool, but you can also use a flat bladed screwdriver. Now, with the two fastenersremoved, we'll go ahead and pull the tray up out of the way and set it aside forreinstallation later. more
11/29/2012 1:39:25 PM
Trailer Wiring Harness Installation - 2006 Toyota Highlander 118248- Video
Today on this 2006 Toyota Highlander, we're going to install part number 118248from Tow Ready. The first step is to go ahead and remove the interior panels to get toour wiring harness. We'll have to remove the access panels, the threshold, and trunk floorpanels and trays. We'll go ahead and locate the port on the driver's side. Somevehicles have a cap. We'll remove the cap if necessary, and then we'll go ahead andinstall the T1 wiring harness. more
8/27/2012 3:10:01 PM
Trailer Wiring Harness Installation - 2006 Toyota Highlander Hybrid- Video
Today on this 2006 Toyota Highlander, we are going to install part number 118248. First off we are going to have to get inside the vehicle. We will open up the hatch. We will start taking apart the floor components. Just roll this back. Flip this forward and this tray needs to come out. There are two rivets for the floor here. Take this out of the way. Next we are going to take this threshold off. We will pop this little rivet right here out. One on each side. And this component comes off and now you need to take this little tray out. There is another rivet right here we have to take out. And there is two nuts on the bottom of the tray that have to come out also. more
10/19/2009 11:26:23 AM
Trailer Wiring Harness Installation - 2006 Toyota Highlander 118248- Video
Today we are going to do an install of part number 118248 the T One connector from Tow Ready. It will be installed on our 2006 Toyota Highlander. To get to our access point which is about down here and underneath this panel. So we will have to roll back the carpeting and pull up the tray and gain access that way. Once you get everything out of the way it is pretty clear that this is the plug right here for the harness. So our T connector can plug right into here. Then our ground wire will actually mount to this ground bolt right here. We took our ground bolt out and we will simply install our ground wire here and run it back through there and install it. Next we will install the module box itself using the self adhesive tape that is on the backside of the connector. more
8/8/2008 4:11:43 AM
