Best 2007 Nissan Altima Hitch Options- Video
Today on our 2007 Nissan Altima we'll be looking at our best hitch options. We have two hitches that we are looking at here today. They are both Class I hitches. On the top we have a Curt, part number C11352. On the bottom we have a Draw-Tite, part number 24796. I'd like to point out one of the obvious difference between our two hitches here today, the Curt is significantly wider than the Draw-Tite. more
9/29/2016 4:21:09 PM
Trailer Hitch Installation - 2007 Nissan Altima - Hidden Hitch- Video
Today, on our 2007 Nissan Altima, we're going to be reviewing, and installing the hidden hitch, customer-fit, class one, trailer hitch receiver, part #60873. Now, you'll see, with the hitch installed, it's going to have that nice, sleek look tucked up underneath the backside of the vehicle. It's going to be that square tubing all the way across the bottom. You're going have that inch and a quarter by an inch and a quarter receiver tube, with a half-inch pinhole going straight through. We also have your chain tie-downs on either side, and the black powder coat finish to help prevent any rust or corrosion. Maximum tongue weight that you can place on your receiver is going to be 200lbs. Maximum tow is going to be 2000lbs. Now, we'll go ahead and get some measurements to help you with selecting bike racks or cargo carriers. From the center of the pinhole, to the outermost part of the bumper is going to be about six inches. From the top of the receiver tube, to the ground, it's going to be about nine, and a quarter, inches. Now, we'll show you have to install the hitch. more
9/25/2015 10:56:18 AM
Trailer Hitch Installation - 2007 Nissan Altima - Draw-Tite- Video
Today on our 2007 Nissan Altima, we're going to be reviewing and installing the Draw-Tite Sport Frame Custom Fit Class 1 Trailer Hitch Receiver. Part number 24796. Now you see with the hitch installed, it's going to have that nice sleek look tucked up underneath the backside of the vehicle. It's going to be that square tubing all the way across the bottom. You're going to have that inch and a 1/4 by inch and a 1/4 receiver tube, with the 1/2 inch pinhole going straight through. You also have your chain tie downs on either side and the black powder coat finish to help prevent any rust or corrosion. more
9/15/2015 10:50:06 AM
