Trailer Hitch Installation - 2006 Mercury Grand Marquis - Curt- Video
Today on this 2006 Mercury Grand Marquis, we're going to review and install the Curt Class III 2-Inch Receiver Hitch, part number 13707. This is what the hitch looks like when it's installed on our Grand Marquis. On first glance, you can't see much of the hitch at all except for the receiver opening right here. Just look at the side of the frame, you can see the body of the hitch where it goes up to the frame just a little bit. Let's go ahead and take a closer look at the detail. It has a nice reinforcement ring around the opening here, which is going to be our 2-inch opening. Back here, we'll use a 5/8 of an inch hitch pin or your favorite locking pin. more
4/13/2016 12:23:04 PM
Trailer Hitch Installation - 2006 Mercury Grand Marquis - Draw-Tite- Video
Today on this 2006 Mercury Grand Marquis, were going to install part number 24526 from Draw-Tite.Alright, this is what the hitch looks like once installed on the vehicle. Next we'll give you some measurements thatll help you out in selecting some accessories such as a bicycle rack or a cargo carrier. From top of receiver opening down to the ground will be about 11 and a quarter inches and from the center of the hitch pin hole to the edge of the bumper will be about five and three-quarter inches.Now we'll go ahead and show you how the hitch is installed. The first thing were going to do is at the very end of the frame, is measure back one-half an inch and make a mark. Next, we'll take the hitch and hold it up in position and line it up with that mark. Now we'll go ahead and support the hitch. more
3/26/2013 5:20:34 AM
Trailer Hitch Installation - 2006 Mercury Grand Marquis- Video
Today we are going to do an install on part number 36116 which is a Class II Frame Trailer Hitch. We will be installing it on a 2006 Mercury Grand Marquis LS. This also applies to Hidden Hitch part number 90139. The hitch gets installed along this frame right here no existing holes to use so basically we will clamp the hitch up there and spray paint our holes. We will then the hitch and drill our holes then reinstall our hitch with the necessary fasteners. First up we are going to lift the hitch up there and clamp it. You need to use of an extra pair of hands because you do not want it falling on you more
7/23/2008 7:35:10 AM
