Best 2009 Honda Odyssey Hitch Options- Video
Today we're going to be taking a look at the best hitch options on our 2009 Honda Odyssey. Now the hitch on the top of our rack here is going to be the CURT class three, part number C13068, followed by the Draw-Tite class three Max-Frame hitch, part number 75270. Our third hitch is going to be the CURT class two, part number C12031. The hitch on the bottom's going to be the Draw-Tite class two, part number 36417. Now you're going to notice that we have a difference in hitches here. The top two are going to be class three hitches, where these bottom two are going to be class two. That's going to give you 2" openings on our class threes and 1-1/4" on our class twos. more
7/25/2016 1:20:21 PM
Trailer Hitch Installation - 2009 Honda Odyssey - Curt- Video
Today on our 2009 Honda Odyssey, we're gonna be installing the Curt hitch part number C12031. This is what a hitch looks like once it's installed. Next, we'll go ahead and give you a couple of measurements to assist you in selecting accessories for your new hitch. From the center of the hitch pinhole to the outermost edge of the bumper is 3 inches. From the top of the receiver tube to the ground is 13 and 3/4 inches. This will assist you in selecting accessories such as a draw bar, a bike rack or a cargo carrier. more
9/7/2012 1:59:28 PM
Trailer Hitch Installation - 2009 Honda Odyssey - Hidden Hitch- Video
Today on our 2009 Honda Odyssey, we're gonna be installing the hidden hitch part number 90153. Before we begin installation, we'll go ahead and lower the exhaust. To lower the exhaust, we'll use a little spray lubricant on the rubber isolator for the rear exhaust hanger. Then we can simply take our crowbar and just remove the isolator from the metal hanger. This point, we can go ahead and point out then attach the points here in the frame. Next, we'll go ahead and take our half-inch nylon tube brush part number 814092 and some spray lubricant to clean up the weldnuts in the frame. more
9/7/2012 12:26:09 PM
Trailer Hitch Installation - 2009 Honda Odyssey - Draw-Tite- Video
Today on our 2009 Honda Odyssey, we'll be installing a draw-tite hitch part number 36417. Before we begin installation, we'll go ahead and lower the exhaust. To lower the exhaust, we'll use a little spray lubricant on the rubber isolator for the rear exhaust hanger. Then we can simply take our crowbar and just remove the isolator from the metal hanger.This point, we can go ahead and point out then attach the points here in the frame. Next, we'll go ahead and take our half-inch nylon tube brush part number 814092 and some spray lubricant to clean up the weldnuts in the frame. After you finish cleaning up the weldnut, I recommend you to take the 12mm bolts and go ahead and drive it in to the weldnut to make sure it goes nice and smoothly. more
9/7/2012 12:25:35 PM
