Trailer Hitch Installation - 2005 Chevrolet Uplander - Curt- Video
Today on our 2005 Chevrolet Uplander well be installing the Curt Trailer Hitch in the class 3 in a 2 Inch Opening, part number 13344. Heres what our hitch looks like installed on our vehicle. Now well go ahead and give you a couple measurements in helping you choose some accessories for your hitch such as a ball mount, a bicycle rack or cargo carrier. From the center of the hitch pin hole to the outermost edge of the bumper is approximately 6 inches. From the top of the opening in the receiver to the ground is 13-3/4 inches. Now lets go ahead and install our hitch. To begin with here well go ahead and point out the locations that were going to use here on the drivers side. There are two existing weld nuts that well need to clean out as well as have to drill a hole once we put the hitch up into place. more
11/25/2014 9:01:12 AM
Trailer Hitch Installation - 2005 Chevrolet Uplander- Video
Today we are installing a Curt hitch, part number 13336 on a 2005 Chevrolet Uplander. First we are going to remove the rubber exhaust hangers and lower exhaust hanger bracket on the passengers side. All right, the next step, it says, is to remove the fascia, but due to previous wiring installation on this model it has already been removed. And the next step, it says, is to disconnect the lower compressor from the drivers side, but this model is not equipped with it. All right, the next step is to use a fish wire to run the carriage bolts and the spacers through the access slots in the frame rail, leaving the carriage bolt and spacer inside the frame rail until the hitch is raised into position. Now you repeat on the passengers side. Now, the next step is to lift the hitch into place and secure it with the bolt and washer. more
1/21/2009 9:19:58 AM
