Best 2013 Chevrolet Traverse Trailer Hitch Options- Video
Hey, everybody. Ryan here at etrailer. Today, we're gonna be checking out our best trailer hitch options for your 2013 Chevy Traverse. Today, we're gonna be looking at three different trailer hitches. Right here, we have the Draw-Tite. Right here, we have the CURT. more
9/19/2022 8:41:07 AM
etrailer.com Trailer Hitch Installation - 2013 Chevrolet Traverse- Video
Today on our 2013 Chevrolet Traverse, we're gonna be taking a look at, and showing you how to install, the etrailer 00:00:05 class III custom fit trailer hitch receiver. So, here's what our hinge is gonna look like once we have it installed. The cross tube's gonna be hidden behind the bumper really nice. And, that appearance panel that pops out, you can actually put it back and it'll be hidden there until we need our hitch.Now, it is a class III, which means it's gonna give us that two inch by two inch receiver tube opening and have a really wide variety of accessories that we could mount up. And, the way we're gonna mount any of our accessories is through the hitch pin hole here on the side. It is gonna accept a standard five inch pin and clip. more
3/7/2019 3:07:11 PM
Trailer Hitch Installation - 2013 Chevrolet Traverse - Curt- Video
Today on our 2013 Chevrolet Traverse we're going to take a look at and also show you how to install the CURT custom fit class three trailer hitch receiver. This offers the 2" by 2" opening. Its part number is 13424. Now here's what our hitch is going to look like installed. As you can see, it's going to remain completely hidden behind our rear fascia. Then we've got an access panel here. more
7/18/2016 4:55:59 PM
Trailer Hitch Installation - 2013 Chevrolet Traverse - Draw-Tite- Video
Today on our 2013 Chevrolet Traverse, we will be installing the draw-tight hitch, part number 75528. Here's what the hitch looks like installed on our vehicle. Now we'll go ahead and give you a couple of measurements in helping you select some accessories for your hitch, such as a ball-mount, bicycle rack, or cargo carrier. From the center of the hitch pin hole to the edge of the bumper is approximately 6-3/4". From the top of the opening of the hitch to the ground is approximately 18-1/2". Now we will go ahead and install our hitch. First we will go ahead and show you the attachment points where the hitch will actually attach to the vehicle. Next we'll go ahead and locate the hangars that need to be removed to lower the exhaust out of the way. Before removing any of the exhaust hangars, we will go ahead and install a safety strap to help support the exhaust once the exhaust hangars have been removed. To get the exhaust hangars off, it helps if you use a little spray lubricant, as well as a pry bar or a large flat-head screwdriver. Now that we have all the exhaust hangars removed and the exhaust is lowered out of the way, we will go ahead and remove the rear fascia panel. To do that, you will see that there are two plastic tabs on the underside of the rear fascia that need to be turned. You will pull down and out towards the back of the vehicle and the rear-center section of the fascia will be removed. Next, we'll need to go ahead and clean out the four weld nuts that are in the vehicle. more
9/30/2014 6:15:57 PM
