Best 2010 Honda CR-V Trailer Wiring Options- Video
Today we're going to be taking a look at the best custom-fit vehicle wiring options for your 2010 Honda CRV. Up top we've got the Tekonsha T1 vehicle wiring harness with four-pole flat trailer connector, part number 118427. On bottom we've got the CURT T-Connector vehicle wiring harness with four-pole flat trailer connector, part number C55106. The biggest difference that you're going to see between these two wiring harnesses is on the Tekonsha the converter box is circuit-protected so even if there's a short in the trailer or in the wiring for our converter box, it's not going to go back and blow the fuse on the vehicle. Then the next difference we'll see is in the amperage ratings that's going to be on each circuit on the four-pole wiring. With the Tekonsha it's going to be rated at five amps on the taillight circuit and 2.1 amps on the stop and turn signal circuits. Where on the CURT, it's going to feature five amps on the taillight circuit but three amps on the stop and turn circuits. more
12/5/2016 3:30:43 PM
Trailer Wiring Harness Installation - 2010 Honda CR-V- Video
Today on our 2010 Honda CRV. We're taking a look at installing the Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector, part number C55106. Now when we're ready to use our 4-pole flat connector, we're simply going to pull up, remove it from the spare tire area, pull it over the trunk of our vehicle or through the hatch, over that weather seal. This weather is going to be thick enough that it's going to protect your wire. It can start running down to your hitch. Go ahead and close our hatch just like so. more
10/27/2015 10:21:31 AM
Trailer Wiring Harness Installation - 2010 Honda CR-V 118427- Video
Today on this 2010 Honda CRV well be installing part number 118427, T1 connector by Tow Ready. Well go ahead and open up the hatch. First thing we want to do is to make sure everything is out of the way. Were going to remove the spare tire cover and get it out of the way. Were going to go ahead and remove the lining bolts with our trim hardware to gain access to the right rear corner panel of the vehicle. With those removed we can go ahead and remove the trim panel. more
11/29/2012 3:09:19 PM
